User manual HP COMPAQ EVO T30 COMPAQ HARDWARE REFERENCE GUIDE FOR THIN CLIENTS

[. . . ] 2­9 PCMCIA Wireless Card Installation . 2­10 Accessing the T1010 PCMCIA Slot . 2­10 Accessing the T30 PCMCIA Slot . 2­11 Hardware Reference Guide iii Contents A Specifications B Security Provisions Securing the Thin Client . [. . . ] In all cases, see the specific installation instructions applicable to the Thin Client option. Flash Memory Installation If your Thin Client can be upgraded with the optional flash memory, use the following instructions as an overview of this procedure. Ä CAUTION: If necessary, back up any data before continuing the installation. instructions, follow In addition to following thesethe flash memory youthe detailed instructions that accompany have purchased. These instructions are available for download from the Compaq website. T20 Flash Memory Installation 1. Follow the applicable instructions in the "General Hardware Installation Sequence" section at the beginning of this chapter. Remove any existing flash memory if installed. 2­6 Hardware Reference Guide Hardware Upgrades 4. Insert the new flash memory with the membrane circuitry facing down as shown in the following illustration. Installing optional flash memory (T20 model shown) 5. Upgrade the Thin Client firmware if necessary. T30 Flash Memory Installation The T30 Thin Client can be upgraded with two physically different types of flash. Use these steps as a general installation overview. Refer to the documentation included in your flash memory option kit for detailed instructions on installing T30 flash memory. Follow the applicable instructions in the "General Hardware Installation Sequence" section at the beginning of this chapter. Remove any existing flash memory if installed. Hardware Reference Guide 2­7 Hardware Upgrades 4. Verify the location of pin 1 on your Flash Memory card and align it with the pin 1 marker shown on the system board. Insert the new flash memory as shown in the following two illustrations. Type One Type Two 6. Upgrade the Thin Client firmware if necessary. 2­8 Hardware Reference Guide Hardware Upgrades SODIMM Installation If your Thin Client can be upgraded with optional SODIMM memory, use the following instructions for an overview of this procedure. Ä CAUTION: If necessary, back up any data before continuing the installation. In addition to following these instructions, follow the instructions that are applicable to your specific Thin Client option. 1. Follow the applicable instructions in the "General Hardware Installation Sequence" section at the beginning of this chapter. Remove any existing SODIMM if installed. Install the module into the socket at a 45° angle 1 until it clicks, then snap the module 2 into position as shown. Installing an optional SODIMM (T20 model shown) 5. Power up the Thin Client. Hardware Reference Guide 2­9 Hardware Upgrades PCMCIA Wireless Card Installation If your Thin Client supports an optional PCMCIA wireless card, follow the Thin Client-related instructions included in the Compaq option kit. Compaq also supports several third-party wireless cards. Visit http://www. compaq. com\support\thinclients for installation instructions. In order to use an optional PCMCIA wireless card, it is necessary to remove the PCMCIA slot cover located on the back of your Thin Client. See the following sections for the instructions applicable to your Thin Client. Accessing the T1010 PCMCIA Slot To access the T1010 PCMCIA slot, perform the following: 1. Remove the screw 1 as shown in the following illustration. [. . . ] Occasionally clean the air vents of the Thin Client. Lint and other foreign matter can block the vents and limit the airflow. Hardware Reference Guide D­1 Routine Thin Client Care and Shipping Preparation Shipping Preparation Follow these suggestions when preparing to ship your Thin Client: 1. Turn off the Thin Client and external devices. Disconnect the power cord from the electrical outlet, then from the Thin Client. [. . . ]