User manual HP COMPAQ EVO W4000 CONVERTIBLE MINITOWER COMPAQ EVO WORKSTATION W4000 CMT HARDWARE REFERENCE GUIDE

[. . . ] b Hardware Reference Guide Evo Workstation W4000 Convertible Minitower Models Document Part Number: 244947-002 January 2002 This book provides basic information for upgrading this series of computers. © 2002 Compaq Computer Corporation Compaq, the Compaq logo, and Evo are trademarks of Compaq Information Technologies Group, L. P. Microsoft, MS-DOS, Windows, and Windows NT are trademarks of Microsoft Corporation. Intel, Pentium, Intel Inside, and Celeron are trademarks of Intel Corporation. All other product names mentioned herein may be trademarks of their respective companies. [. . . ] For more information about preventing electrostatic damage, refer to Appendix E, "Electrostatic Discharge. " I Handle a drive carefully; do not drop it. I Do not use excessive force when inserting a drive. I Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as monitors or speakers. le: Installing a CD-ROM, DVD-ROM, or other Removable Storage Device 1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock. Shut down the operating system properly, then turn off the computer and any external devices, disconnect the power cord from the power outlet, and remove the computer access panel. 2­14 Hardware Reference Guide Hardware Upgrades 3. Install two guide screws on each side of the drive 1. Some options use metric hardware. Extra guide screws are provided on the front of the chassis, under the front bezel. The Compaq supplied metric screws are black. Install the drive in the desired drive bay by sliding it into the front of the drive cage 2; the drivelock automatically secures the drive in the bay. Be sure the guide screws line up with the guide slots in the drive cage. Aligning the Guide Screws and Installing an Optional 5. 25-Inch Drive on a Minitower (top) and a Desktop (bottom) Hardware Reference Guide 2­15 Hardware Upgrades 5. Connect the drive power 1 and signal 2 cables and, if it is a CD-ROM or DVD-ROM drive and if analog audio is preferred to digital audio, connect the audio cable 3. The other end of the audio cable should be connected to the embedded audio connector on the system board. Connecting the Drive Cables 6. Remove the appropriate bezel blank from the subpanel inside the front bezel. See the section "Removing Bezel Blanks" for more information. See the section "Installation Sequence" for more information. Installing a 3. 5-Inch Drive into a 5. 25-Inch Drive Bay 1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock. Shut down the operating system properly, then turn off the computer and any external drives, disconnect the power cord from the power outlet, and remove the computer access panel. Install one guide screw on the right side of the drive. 2­16 Hardware Reference Guide Hardware Upgrades 5. Insert the drive into the adapter 2 so that the guide screw aligns in the slot, and then attach with two retaining screws. Snap on the brace 1 and attach the drive bezel 3 to the front of the adapter. Attaching a 3. 5-Inch Drive to the 5. 25-Inch Adapter Hardware Reference Guide 2­17 Hardware Upgrades 7. Install two guide screws on each side of the adapter 1. Install the adapter in the desired drive bay 2 by sliding it into the front of the drive cage; the drivelock automatically secures the adapter when it snaps into place. primary should only be installed The 3. [. . . ] Keep liquids away from the computer and keyboard. Never cover the ventilation slots on the monitor with any type of material. Turn off the computer before you do either of the following: I I I I I I Wipe the exterior of the computer with a soft, damp cloth as needed. Using cleaning products may discolor or damage the finish. [. . . ]