User manual HP COMPAQ STORAGEWORKS TL881 DLT MINI-LIBRARY

[. . . ] TL881 MiniLibrary System Users Guide First Edition (May 1999) Part Number ER-TL881-UA. A01/138247-001 Compaq Computer Corporation Notice The information in this publication is subject to change without notice. COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN, NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. THIS INFORMATION IS PROVIDED "AS IS" AND COMPAQ COMPUTER CORPORATION DISCLAIMS ANY WARRANTIES, EXPRESS, IMPLIED OR STATUTORY AND EXPRESSLY DISCLAIMS THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, GOOD TITLE AND AGAINST INFRINGEMENT. [. . . ] Determine where the module you are installing is going to be located relative to the top module. If the module you are installing is going to be located on the top of the stack or the second from the top (unit 1 or 2), the parts which you will need to install this module are: 2 pieces 968312-101 Installation 3-21 4 pieces 968313-101 b. If the module you are installing is going to be located third or fourth from the top (unit 3 and 4), the parts which you will need to install this module are: 2 pieces 4 pieces 968319-101 968320-101 c. If the module you are installing is going to be located fifth or sixth from the top (unit 5 and 6), the parts which you will need to install this module are: 2 pieces 4 pieces 968608-101 968609-101 d. Sort out the appropriate adapters for your application. The part number is stamped in the middle of the part for identification. Next to each mounting hole in the bracket, numbers are stamped which correspond to the module number. If you are installing the first module for example, mount the flat head screws (P/N 213164-108) through the holes marked #1. Metric Rackmount Procedure: 1. Refer to Figure 3-13, Metric Rackmount Installation Layout. Mount the appropriate metric conversion bracket to both ends of the slide using the 10-32 nuts provided in the slide kit. Do this for both the left and right slide assembly. For modules 1 and 2, use P/N 968313-101. For modules 3 and 4, use P/N 968320-101; for modules 5 and 6, use P/N 968609-101 Make sure that these brackets are oriented so that the numbers are right side up in all corners. Mounting the bracket/slide assembly to the StorageWorks cabinet: If installing the first module, select a mounting location: a. Mount each slide/bracket assembly to the rack by aligning the two mounting holes marked #1 to holes on the rack. Start by mounting the slide/bracket assembly to the rear of the StorageWorks first. Hold the bracket/slide assembly in place with one hand, fasten a mounting screw to the holes marked #1. To mount the front bracket, place bracket (P/N 968312-101) in front of the rack with the holes marked #1 aligned to the holes on the rack. 3-22 Compaq TL881 Minilibrary System Users Guide c. Extend the slide/bracket assembly forward to mate with the rack. Align the holes marked #1 on the slide/bracket assembly with the hole #1 on the front bracket and fasten two mounting screws through the two #1 holes. Be careful to mount all four brackets at the same height. You can use a ruler or count holes to achieve this. [. . . ] For best performance, use CompacTape IV cartridges in the library. DO NOT use CompacTape I or CompacTape II cartridges. NOTE: To order additional tape cartridges, contact you Compaq authorized dealer or resealler. Applying Bar Code Labels Before placing a cartridge in the library, you must apply a bar code label that uniquely identifies it to the library. When applying the bar code label: s s Use only the labels provided with the library. [. . . ]