User manual HP COMPAQ T5510 THIN CLIENT

[. . . ] Terminal Emulation User's Guide Trademarks ADDS Viewpoint A2 is a trademark of Applied Digital Data Systems Inc. AIX is a registered trademark of International Business Machines Corporation. DEC, VT52, VT100, VT131, VT220, VT300, VT320, VT340, VT400 and VT420 are registered trademarks of Digital Equipment Corporation. Hazeltine is a trademark of Esprit Systems, Inc. [. . . ] CR) This text box is used to specify the characters that are to indicate the end of a line in a data block. To change the current definition, delete the definition displayed in the text box and type in the new one, either as the control key character equivalent or the decimal value of the ASCII character. For example, the default ASCII character CR can be entered by typing the characters ^ and M, representing the keys Ctrl + M which, when pressed together would generate the CR code. Decimal values are entered as three-digit numbers immediately preceded by an underscore character. Values with only two digits must be preceded by a zero. For example, the decimal value of CR is 13, so this would be entered as _013. Refer to the ASCII character table in the Character Sets appendix for code and decimal references. End of Block Characters Factory default: None This specifies the characters that are to indicate the end of a block of data. To change the current definition, delete the definition displayed in the text box and type in the new one, either as the control key character equivalent or the decimal value of the ASCII character. For example, the ASCII character CR can be entered by typing the characters ^ and M, representing the keys Ctrl + M which, when pressed together would generate the CR code. Decimal values are entered as three-digit numbers immediately preceded by an underscore character. Values with only two digits must be preceded by a zero. For example, the decimal value of CR is 13, so this would be entered as _013. Refer to the ASCII character table in the Character Sets appendix for code and decimal references. 5-64 Setup Menus Attributes This dialog box is displayed by selecting Attributes in the Settings menu. It enables you to specify the colours used in the emulation workspace and how text with attributes is displayed. To change the way a screen element is displayed, select the relevant item from the Screen Element list box, for example, Bold (BD) for characters with the bold attribute. The settings of the other options in the dialog box will change to reflect the settings currently assigned to the screen element, and the Sample Text window will show how the screen element is actually displayed with these settings. Text with attributes can be displayed in various ways. For example, characters with the underline attribute can be displayed as standard (e. g. underlined only), as a particular colour only (e. g. green without the underline), or with both attribute and a specific colour (e. g. The Attribute options allow you to enable or disable any of the attributes normally associated with the currently selected screen element. [. . . ] Host print protocol is not supported. D-4 Product Specification Stratus V102 Specification: V102 Display Terminal Operator's Manual (TVI 131974-00 June 1985). Limitations: Page print flip mode not supported. Serial configuration commands not supported. Select character set commands not supported. Tandem 6526/6530 Emulation Specification: Tandem 653x Multi-Page Terminal Programmer's Guide (82310-B00 December 1983). Limitations: Telnet Line-Mode is not supported. Ansi media copy commands are not supported. [. . . ]