User manual HP DESIGNJET 4500 DESIGNJET 4500 PRINTER SERIES - SETUP POSTER

[. . . ] Page Count Paper Type Ink Coverage 26 (13 front and 13 back) HP standard 50# book (69 to 80g/m2) recycled offset or equivalent 4-color process (CMYK) 4/4 If recycled paper is used, add the recycled paper logo and text. If you have bought the HP Designjet 4500 with a scanner, you can reduce the overall setup time by assembling the scanner first and then switching it on. The scanner will take one hour to warm up when started for the first time. What you will need for this procedure Because some of the components of the printer are bulky, you will need up to four people to lift them. [. . . ] Rotate the printer until its rear rests on the spare and consumables boxes and the wheels with the anti-slip material touch the floor. Remove the pallet before trying to lift the printer into an upright position. Using four people and the hand holds on the rear of the printer body, carefully lift the printer into an upright position. The anti-slip material should stop the printer from sliding forwards. Position the left leg cover on the front of the left leg (1), then clip the rear edge (2) into place. Position the right leg cover on the front of the right leg (1), then clip the rear edge (2) into place. Remove the anti-slip material from the two rear wheels on the stand assembly. Then remove the two window inserts and the ink tube packing material. Remove the protective covering from the printer window and the front panel screen. Angle the holder at the top (1), then position the two hooks and clip the lower part (2) to the rear of the printer. Beware, you must remove this plastic screw. Beware, you must remove this plastic screw. Remove the two yellow plastic screws from the right and left side of the paper feed. Remove the two yellow plastic screws from the left and right side of Drawer 2. Two FireWire sockets are provided for direct connection to computers. If the power light on the front panel remains off, press the Power key to switch on the printer. Plug the power cable into the rear of the printer, then plug the other end into the AC power outlet. Turn the power switch at the rear of the printer to the on position. Note: This printer is Energy Star compliant and can be left switched on without wasting energy. Wait until you see this message (~10 minutes). Highlight your language using the Up and Down keys. The front panel will now display how to install the ink supplies. [. . . ] Feed the paper onto the platen of Drawer 2. Align the paper with the blue line on the right side of the platen. Using the stops, carefully wind the excess paper back on to the spindle. Caution: do not attempt to use this socket for any other purpose. [. . . ]