User manual HP DLT VS80 TAPE DRIVE DLT VS80 TAPE DRIVE INSTALLATION POSTER

[. . . ] About this document Installing the internal tape drive Setting the SCSI ID Installation Instructions This document provides instructions for installing the HP StorageWorks DLT VS80 Tape Drive. Detailed, translated versions of these instructions can be found in the reference guide on the enclosed documentation CD. SCSI ID Jumpers hp StorageWorks DLT VS80 Tape Drive Unpacking the tape drive SELECT EJECT ENTER Caution: If the room where you are unpacking the drive differs from the temperature at which the tape drive was shipped or stored by 30º F (15º C) or more, let the drive acclimate to the surrounding environment for at least 12 hours before opening the shipping carton. SCSI ID Jumper Block 0 1 2 3 4 5 6 7 Figure 5: Inserting the tape drive Note: An LVD/SE SCSI host adapter must be present in the server. Figure 3: SCSI ID settings Note: When setting the SCSI ID: Make sure that each SCSI device on a SCSI bus has a unique SCSI ID. [. . . ] This document contains proprietary information, which is protected by copyright. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of Hewlett-Packard. The information contained in this document is subject to change without notice. Product names mentioned herein may be trademarks of their respective companies as reflected by an associated footnote. Hewlett-Packard Company shall not be liable for technical or editorial errors or omissions contained herein. The information is provided "as is" without warranty of any kind and is subject to change without notice. The warranties for Hewlett-Packard Company products are set forth in the express limited warranty statements for such products. Nothing herein should be construed as constituting an additional warranty. Required tools Figure 6: Ribbon cable with terminator The DLT VS80 tape drive ships with a ribbon cable that is already terminated as shown in Figure 6. If you use a cable other than the one provided, be sure that the cable is terminated at each end. Figure 4: Removing power from all devices 1 Figure 2: Required tools Caution: Failure to remove power from all devices could result in damage to the DLT VS80 tape drive or other devices. Note: Your server may differ from the following illustrations. Different rails or cover removal from a drive bay may be required. Refer to the documentation included with your server. 2 External drive: DLT VS80 Tape Drive Installation Instruction Third Edition(September 2003) Part Number: 289066-003 Small screwdriver Phillips screwdriver Torx-15 screwdriver Internal drive: Figure 7: Connecting the power and signal cable 289066- 003 [bar code goes here in text box, if applicable] 1 Terminated SCSI cable 2 Power connector See other side 1. Attach the other end of the SCSI ribbon cable to the SCSI host adapter. Installing the external tape drive Connecting a single drive Note: An LVD/SE SCSI host adapter must be present in the server. Daisy-chaining Note: To daisy-chain, you must purchase additional cables. Refer to the Quick Specs at http://www. hp. com for cable option part numbers. 1 2 6 in. 1 2 2 Figure 8: Connecting tape drive to the host bus adapter (HBA) Figure 9: Preparing the external drive for installation 1 3 Setting the SCSI ID Figure 11: Connecting a single internal tape drive Caution: Do not use a pencil; small bits of lead could contaminate the drive. [. . . ] This equipment is designed for connection to a grounded (earthed) power outlet. The grounding plug is an important safety feature. [. . . ]