User manual HP E-VECTRA

[. . . ] Quick User's Guide See inside for information on: Setting Up your e-Vectra and more. . . www. hp. com/go/vectrasupport Notice The information contained in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. This document contains proprietary information that is protected by copyright. [. . . ] Any shock may damage the drive and prevent it from functioning correctly. Unplug the AC adapter from the wall socket. 2 Using the key, unlock the port control system (if installed) and hard drive compartment cover at the rear of the e-Vectra. 3 Disconnect the power cord and any telecommunication cables. 4 Slide back and then lift off the compartment cover. 17 Returning Your e-Vectra for Repair Step 4 Returning Your e-Vectra for Repair 5 Lift the rear of the hard drive tray clear of the e-Vectra using the handle. This is to gain access to the data and power connectors. 7 Using the handle, lift the hard drive tray out of the e-Vectra. Step 5 Step 6 Step 7 8 Place the hard disk drive tray in an antistatic bag and store it in a safe place. Do not remove the hard disk drive from the drive tray. Returning Your e-Vectra for Replacing the Hard Disk 1 Insert the protruding pins on the front of the hard disk drive tray in the guiding grooves inside the hard disk drive compartment, then slide the drive tray into position. 2 Lift the handle on the drive tray until the drives rear connectors are accessible, then, reconnect the power and data cables. 3 Lower the rear of the hard disk drive tray into the drive compartment, then click the handle back into position. 4 Ensure that all the drive cables are safely inside the compartment (not trapped or snagging on anything). 5 Replace the compartment cover and slide it back into position. 6 Reconnect the cables and port control system (refer to "Securing Your e-Vectra" on page 7). 18 HP Hardware Warranty HP Hardware Warranty General This HP Hardware Warranty statement gives you, the customer, express warranty rights from HP, the Manufacturer. Please refer to HP's web site for an extensive description of your warranty entitlements. In addition, you may also have other legal rights under applicable local law or special written agreement with HP. FOR CONSUMER TRANSACTIONS IN AUSTRALIA AND NEW ZEALAND, THE WARRANTY TERMS CONTAINED IN THIS STATEMENT, EXCEPT TO THE EXTENT LAWFULLY PERMITTED, DO NOT EXCLUDE, RESTRICT, OR MODIFY BUT ARE IN ADDITION TO THE MANDATORY STATUTORY RIGHTS APPLICABLE TO THE SALE OF THIS PRODUCT TO YOU. THE LAWS OF YOUR COUNTRY MAY PROVIDE FOR DIFFERENT WARRANTY RIGHTS. IF SO, YOUR HP AUTHORIZED SUPPORT PROVIDER OR HP SALES AND SERVICE OFFICE CAN PROVIDE YOU WITH DETAILS. Warranty Repair or Replacement HP Hardware During the applicable warranty period, HP warrants that your HP Hardware, Accessory or Supply will be free from defects in materials and workmanship. Except as indicated above, however, HP does not warrant that any HP Hardware, Accessory or Supply will operate uninterrupted or errorfree. During the product warranty period, HP will, within a reasonable time, repair your product or if unable to repair, refund (in the amount of the product purchase price) upon prompt return of the product to your HP Authorized Support Provider or other HP designate. Unless otherwise stated or agreed upon in writing with HP, all hardware components must be returned for refund with the entire central processor unit. [. . . ] Les piles usées seront acceptées gratuitement. 26 Recycling Your e-Vectra Warnung Wenn die Batterie nicht korreckt eingebaut wird, besteht Explosionsgefahr. Zu ihrer eigenen Sicherheit sollten Sie nicht versuchen, die Batterie wiederaufzuladen, zu zerlegen oder die alte Batterie zu verbrennen. Tauschen Sie die Batterie nur gegen den gleichen oder ähnlichen Typ aus, der vom Hersteller empfolen wird. Bei der in diesem e-Vectra intergrierten Batterie handeltes sich um eine Lithium-Batterie, die keine Schwermetalle enthält. [. . . ]