User manual HP IPAQ HW6500 CINGULAR MOBILE MESSENGER IPAQ HW6500 MOBILE MESSENGER SERIES PRODUCT MAINTENANCE GUIDE

[. . . ] HP iPAQ hw6500 Mobile Messenger series Product Maintenance Guide Kudu cover 2. p65 1 4/12/2006, 6:41 PM 430524-001. book Page i Tuesday, May 2, 2006 2:05 PM © 2006 Hewlett-Packard Development Company, L. P. iPAQ is a trademark of Hewlett-Packard Development Company, L. P. Microsoft, Windows, the Windows logo, Outlook, and ActiveSync are trademarks of Microsoft Corporation in the U. S. HP iPAQ hw6500 Mobile Messenger series is Powered by Windows Mobile® 2003 Second Edition software for Pocket PC. SD Logo is a trademark of its proprietor. Bluetooth is a trademark owned by its proprietor and used by Hewlett-Packard Company under license. [. . . ] Use the stylus to lightly press and release the Reset button. The HP iPAQ restarts and displays the Today screen. NOTE: A soft reset does not change any Bluetooth or ActiveSync settings on your HP iPAQ. 11 430524-001. book Page 12 Tuesday, May 2, 2006 2:05 PM Performing a Hard ("Full") Reset Perform a hard reset (also known as a full reset) when you want to clear all settings, programs, and data from Random-Access Memory (RAM). Perform a hard reset if you are experiencing problems after you have installed a third-party application on your device. Some of these problems can include applications hanging, error messages, and the device not responding. HP recommends performing a soft reset before attempting a hard reset. If the soft reset does not remedy the problem, you should then perform a hard reset. CAUTION: If you perform a hard reset, your HP iPAQ returns to its default settings and loses all information (files, settings, etc. ) that is not recorded in Read-Only Memory (ROM). Files stored in iPAQ File Store will not be deleted if you perform a full (hard) reset. You will know that a hard reset has been successful when the device prompts you to run through the initial startup sequence again. While holding the Power button, use the stylus to lightly press the Reset button on the bottom right side of the HP iPAQ for about five seconds. 3. Once the HP iPAQ screen fades, release the Power button and remove the stylus from the Reset button. Using iPAQ File Store The iPAQ File Store is an unused portion of Read-Only Memory (ROM) where the operating system and built-in programs are stored. Copy the file(s) you want to store in iPAQ File Store. Tap Start > Programs > File Explorer > My Device drop down list box > iPAQ File Store. 12 430524-001. book Page 13 Tuesday, May 2, 2006 2:05 PM Protecting Your HP iPAQ Display CAUTION: The screen and camera lens of your HP iPAQ are made of glass and can be damaged or broken by drops, impacts, or pressure. NOTE: HP is not responsible for damage that occurs as a result of your failure to follow the instructions that came with your HP branded product. Refer to the warranty document included with your HP iPAQ for more information. You should observe the following practices to protect the screen and camera lens of your HP iPAQ from damage. · · · · When transporting your HP iPAQ in a purse, pocket, briefcase, etc. , ensure the device does not get compressed, bent, dropped, hit, or sat on. Do not place anything on top of your HP iPAQ. Do not bang your HP iPAQ against hard objects. Never use any device other than the stylus that comes with the HP iPAQ or an approved replacement to tap or write on the screen. If you lose or break your stylus, you can purchase extras at www. cingular. com/accessories or at a Cingular retail outlet. Clean your HP iPAQ by wiping the screen, the camera lens, and the exterior with a soft, damp cloth lightly moistened only with water. [. . . ] To download the HP iPAQ ActivSync 3. 8 and access Microsoft's troubleshooting site go to Cradle. http://www. microsoft. com/windowsmobile/help/ activesync/default. mspx · Be sure your HP iPAQ is connected to the HP iPAQ Cradle, and that the cradle is connected to your computer. · Be sure your HP iPAQ is securely seated in the cradle and is making contact with the cradle connector. · Be sure you are running Microsoft Windows 98SE, Me, 2000, or XP and that you have installed Microsoft ActiveSync 3. 8 on your computer. Also be sure you are connecting directly to a USB port on your computer and not through a USB hub. · Try resetting your HP iPAQ. · Uninstall and reinstall ActiveSync. [. . . ]