User manual HP JETDIRECT EN1700 IPV4/IPV6 PRINT SERVER JETDIRECT PRINT SERVER ADMINISTRATOR'S GUIDE (FIRMWARE V.36)

[. . . ] HP Jetdirect Print Servers Administrator's Guide HP Jetdirect Firmware V. 36 J7961G (635n) J7997G (630n) J7988G (en1700) J7993E (embedded) J8003E (embedded) J8004E (embedded) J8005E (embedded) HP Jetdirect Print Servers Administrator's Guide (Firmware V. 36) © 2007 Copyright Hewlett-Packard Development Company, L. P. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. The information contained in this document is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. [. . . ] Creating an SNMP v3 account is not recommended if you manage devices using HP Web Jetadmin. Enable SNMPv1/v2 read-only access: Enable this option to allow support of current tools that rely on SNMP v1/v2 for device discovery and status. The Configuration Review page displays all the current settings that may affect security. Click Finish to set your basic security selections. Custom Security This option allows you to manually set all available security settings supported by your print server. For more information on specific parameters and selections, see the information for the Mgmt. Protocols on page 91 and Authorization on page 86 menu pages. The Administrator Account page is used to enter the administrator password. NOTE: To clear the Administrator Password, enter blank entries, or refer to the Admin. page is used for HTTPS (secure HTTP) configuration, including certificates and encryption levels. The Management Tools page allows configuration of management protocols that are not secure (such as RCFG, Telnet and FTP firmware updates). SNMP Configuration pages are used to configure specific SNMP settings: Enable SNMPv1/v2: Enable this option to allow management software that use SNMP v1/v2. If selected the SNMPv1/v2 Configuration page is displayed to configure SNMP community names. Enable SNMPv3: (Full-featured print servers only) Enable this option to create an SNMP v3 account. Creating an SNMP v3 account is not recommended if you manage devices using HP Web Jetadmin. See SNMP on page 76. ENWW Networking Tab 85 Table 4-15 Wizard Security Levels (continued) Security Level Description The Access Control page is used to set up an Access Control List, if desired to control host access to the device. This feature is available on selected full-featured print servers only. The Print Protocols and Services page is used to enable or disable network printing, print services, and device discovery protocols that may affect security. The Configuration Review page displays all the current settings that may affect security. Click Finish to set your basic security selections. Restore Defaults This page is used to restore the configuration parameters listed to factory default values. The parameters displayed depend on the features supported by the print server. Only the configuration settings listed are restored to factory defaults, other configuration settings are not affected. Authorization The Authorization page provides tabs that allow you to control access to the device, as well as to device configuration and management features. In addition, you may configure certificates for client and server authentication. Admin. [. . . ] This can be in the form of a textual message at program startup or in documentation (online or textual) provided with the package. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. Redistributions of source code must retain the copyright notice, this list of conditions and the following disclaimer. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution. [. . . ]