User manual HP KAYAK XW 04XX

[. . . ] DiagTools User's Guide HP Vectra PCs HP Kayak PC Workstations Notice The information contained in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. This document contains proprietary information that is protected by copyright. [. . . ] Re-start system and check BIOS setup parameters. If error persists install new system board. Re-start system and check BIOS setup parameters. If error persists install new system board. 0070h 0071h 0072h Configuration mismatch in CMOS RAM. 0073h CMOS RAM memory size. 0074h CMOS RAM time is invalid. 0075h Time-base frequency divider set at incorrect value. 0076h Divider output frequency set to an incorrect value. English 47 Appendix A The Error Codes 0001h ­ 00CCh: System Error Codes Code 0077h 0078h Explanation Periodic time update cycle not occurring. CMOS RAM checksum error detected. Details/Parts to Check Real Time Clock (RTC) error. If error persists, install new system board. If error persists, install new system board. You attempted to run this test on a system that does not have an EISA architecture. If error persists, install new system board. Check that the SCSI controller is correctly installed. 0079h CMOS RAM fails to hold data. 0080h 0081h 0082h 0083h This test runs on EISA systems only EISA software NMI test failed EISA fail-safe timer test failed PCI System Bus scan test failed. 0084h 0085h 0086h 0087h 0088h 008Ah Cannot access PCI devices through the FIND_PCI_DEVICE call. Reading configuration space registers on boundary conditions failed. Consistency checking of PCI configuration space failed. BIOS32 service directory integrity check failed. Buffer data mismatch. 48 English Appendix A The Error Codes 0001h ­ 00CCh: System Error Codes Code 0090h 0091h 0094h 0095h 0096h 0097h 0098h 0099h 009Ah 009Bh 009Ch 009Dh 009Eh 009Fh 00A0h 00A1h 00A2h 00A3h Explanation PnP function 00 failed. Number of system device nodes is not the same as reported. One or more nodes have larger than reported size. No EISA bus system device node Motherboard has no EISA ID One or more EISA slots are not configured. ESCD size is too big. Details/Parts to Check Install new system BIOS. If error persists, install new system board. If error persists, install new system BIOS. Delete drivers before running DiagTools. If error persists, install new system board. [. . . ] Check processor, L2 cache and main memory are correctly installed. If problem persists, install new: · L2 memory (if installed in accessory slot), or · processor (if integrated on the processor card). Check processor, L2 cache and main memory are correctly installed. If problem persists, install new: · L2 memory (if installed in accessory slot), or · processor (if integrated on the processor card). [. . . ]