User manual HP LASERJET 1220SE Quick Start

[. . . ] This equipment generates, uses, and can radiate radio frequency energy. If this equipment is not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Allow space behind the printer for output from the straight-through media doors. Pull the sides of the door forward until the door locks in its open position. 1) Grasp the left side panel using the finger hole. Remove the scanner access cover from the left side panel. Save the scanner access cover in case you remove the scanner. Firmly slide the copier/scanner towards the rear until it snaps into place. Connect one cable to the proper port and run the cable through the cable slot. 1) Insert the left side panel tabs behind the edge of the front panel. Remove the mylar tape by breaking the tab on the left and pulling the tape completely out. Insert the cartridge into the printer, making sure that the toner cartridge is in position. 1) Slide the printer media input tray in and down at an angle until it fits securely in the printer. 2) Slide the media guides out and back to accommodate the media. Slide the guides until they are flush with the media. Wait until the ready light is illuminated and press the Go button. 1) If no lights are on, check the power cord, then press the Go button. 3) If the bottom light is blinking, check the toner cartridge for proper installation, put media in the input tray, make sure all doors are closed, or check for media jams. [. . . ] If you had any problems, refer to the troubleshooting chapters in the electronic user guide or call 1-208-323-2551. 4) Select Specify a location, then type x:\98USB\ (where x is the letter of your CD-ROM drive. 5) Under Copy manufacturer's files from, type x:\2k\ (where x is the letter of your CD-ROM drive), and click OK. [. . . ]