User manual HP LASERJET 6P/MP LASERJET, COLOR LASERJET AND LASERJET MFP AND ALL-IN-ONES - WINDOWS 98, 98 SECO

[. . . ] Hewlett-Packard makes no warranty of any kind with respect to this information. HEWLETT-PACKARD SPECIFICALLY DISCLAIMS THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE Hewlett-Packard shall not be liable for any direct, indirect, incidental, consequential, or other damage alleged in connection with the furnishing or use of this information. GOVERNMENT USERS: RESTRICTED RIGHTS COMMERCIAL COMPUTER SOFTWARE: Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c)(1)(ii) of the Rights in Technical Data Clause at DFARS 52. 227-7013. Material scanned by this product may be protected by governmental laws and other regulations, such as copyright laws. [. . . ] a Purchase and install a supported HP JetDirect print server or check that the one you have is supported. (See page 13 for a list of supported print servers. See the documentation for the print server to install it. ) b Test the hardware installation by printing a configuration page for the HP JetDirect print server. To do this, press Test on the print server. (If the page does not print, use ASCII as the printer language. See the documentation for the print server for further instructions. ) c Check the model or firmware revision number, which is located in the first section of the configuration page you just printed. · If you have a 170X print server and the model number is not J3258B, you must get a new print server. · If you have a 300X or 500X print server and the firmware revision number is not H. 08. 00 or J. 08. 00 or higher, you must upgrade firmware before proceeding. (See "Upgrading firmware" below. ) d Connect the HP LaserJet 3150 product to the print server. (See the documentation for the print server. ) e Important!Unplug the power cord for the HP LaserJet 3150 product and replug it in. The HP LaserJet 3150 product does not use this type of port. The HP LaserJet 3150 product may be assigned to the LPT1 port at installation. Do not redirect the product from the default installed port to another port, such as an HP JetDirect port, or the product will not work correctly. To install software Note To install the software on Windows NT 4. 0 or 2000, you must have administrator privileges (on start and restart). 1 2 Quit all open programs using the Close Programs or Task Manager dialog box. Insert the CD-ROM into the CD-ROM drive (usually D or E). When the welcome screen opens, follow the directions on screen. (If the welcome screen does not open, click Start, and then Run. Type X:SETUP, replacing "X" with the letter of your drive, and click OK. ) Follow the instructions on the screen. Only one person should set the fax settings. When you reach the fax set up portion of the installation, choose Skip if you know someone else set the fax settings, or if the control panel display on the product says READY. Remove the CD-ROM when the setup is finished. [. . . ] HP does not warrant that the operation of HP products will be uninterrupted or error free. If HP is unable, within a reasonable time, to repair or replace any product to a condition as warranted, you will be entitled to a refund of the purchase price upon prompt return of the product. HP products may contain remanufactured parts equivalent to a new in performance or may have been subject to incidental use. Warranty does not apply to defects resulting from (a) improper or inadequate maintenance or calibration, (b) software, interfacing, parts or supplies not supplied by HP, (c) unauthorized modification or misuse, (d) operation outside of the published environmental specifications for the product, or (d) improper site preparation or maintenance. 2 3 4 5 74 4 Warranty EN 6 HP MAKES NO OTHER EXPRESS WARRANTY OR CONDITION WHETHER WRITTEN OR ORAL. [. . . ]