User manual HP LASERJET 9500HDN

[. . . ] user guide hp color LaserJet 9500n hp color LaserJet 9500hdn hp color LaserJet 9500n and 9500hdn user guide Copyright Hewlett-Packard Company 2003 All Rights Reserved. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. The information contained in this document is subject to change without notice. Part number: C8546-90987 Edition 1, 06/2003 Trademark Credits Acrobat®, Adobe®, and PostScript® are trademarks of Adobe Systems Incorporated. [. . . ] To do this, stand on the left side of the output device and pull the device straight toward you. Remove the duplexer by pressing the green lever down and pulling the unit out until it stops. Lift the two green levers in the duplexer and remove any media that is underneath. Remove the duplexer completely. 6 2 2 3 4 5 4 ENWW Clearing jams 117 http://www. hp. com/support/lj9500 6 WARNING Avoid touching the fusing area above the duplexer. 6 7 8 Reach far into the duplexer area and remove any media that you find there. Reinstall the duplexer by sliding it into the printer until it locks into place. If an optional output device is installed, push it back into place. Note Any time a jam occurs in the fuser area (including the lower left door area), the printer automatically sends a cleaning page through the paper path to remove loose toner. 7 8 118 Chapter 6 ­ Solving problems Rev. 1. 0 1 Clearing jams from the output areas Fuser jam, lower left door Follow these directions to clear jams in the lower left door (fuser area). 1 If an optional output device is installed, move it away from the printer to gain access to the left door. To do this, stand on the left side of the output device and pull the device straight toward you. If the jammed media is visible, remove it from the printer. Then close the upper right door and continue printing. If the jammed media is not visible, go to step 4. 6 2 2 3 3 ENWW Clearing jams 119 http://www. hp. com/support/lj9500 4 4 Open the lower left door. WARNING Avoid touching the adjacent fusing area. It can be hot. 5 5 6 If a duplexer is installed, press the green tab and slide it partially out of the printer. Remove any jammed or damaged media from this area by pulling the media out of the printer. Lift the green tabs and remove any jammed or damaged media. Make sure to remove all pieces of torn media. 6 120 Chapter 6 ­ Solving problems Rev. 1. 0 7 7 Close the lower left door. If an optional output device is installed, push it back into place. Note Any time a jam occurs in the fuser area (including the lower left door area), the printer automatically sends a cleaning page through the paper path to remove loose toner. 6 ENWW Clearing jams 121 http://www. hp. com/support/lj9500 1 Jam in the top output bin Follow these directions to clear jams in the top output bin. [. . . ] See supplies control panel alphabetical messages 143 buttons 16 help 20 information pages 141 lights 16, 17 menus 18 numerical messages 155 security settings 142 settings 19 supplies status indicators 169 cost-accounting information 47 covers printing 34 recommended media 39 curl, troubleshooting 76 custom media loading 95 sizes supported 91 tray settings 54 ENWW Index 235 http://www. hp. com/support/lj9500 customer support during warranty 209 online 215 printer information 214 cyan print cartridge. See print cartridges D Data light on control panel interpreting 17 locating 16 Declaration of Conformity 227 default settings 23 defects, print quality 72 Detail halftone option 81 Diagnostics menu, control panel 18 different first page, printing 34 DIMMs errors 162 installed personalities and options 142 display, matching color 83 display. See control panel documentation 11, 12 door jams, clearing 119 236 Index dots, troubleshooting 76 downloading firmware 46 HP Web Jetadmin 46 print jobs 25 drivers default settings 23 help 11, 14 opening 22 version number 214 dropouts, troubleshooting 75 drums. See image drums duplex printing accessory jams, clearing 117 media supported 93 media, loading 96 prepunched paper, loading 98, 99 using 24 E edge control settings 82 edges, printing 36 e-mail support 215 Rev. [. . . ]