User manual HP LASERJET IIP PRINTER LASERJET, COLOR LASERJET AND LASERJET MFP AND ALL-IN-ONES - WINDOWS 98, 98 SECO

[. . . ] Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editiorial errors or omissions contained herein. Edition 1, 9/2004 Trademark Credits Microsoft®, Windows®, are U. S. registered trademarks of Microsoft Corporation. [. . . ] The String Name parameter names the string; the Value parameter defines its content. When a string name is specified for a prepend or append string (in the table at the top of the browser window), the line printer daemon sends the value of that string to the printer before or after the print data (as appropriate). Character values can be anywhere in the extended ASCII range of 0 to 255 (hex 00 to FF). You can specify a non-printing character using its hexadecimal value, by entering a backslash followed by two hexadecimal characters. For example, to enter the escape character (hex 1B), type in \1B. If your string includes the backslash character itself, specify it as \5C. The maximum number of characters you can type into this field is 240. The characters in the field are checked for hexadecimal values, converted if necessary, and stored internally. The maximum number of characters stored internally in the string is 80; any characters that exceed this are discarded. To set up a user-defined print queue, you first define the strings, assign them as prepend or append strings, and define the queue type. Once you have defined an LPD queue, you specify its use by setting up an LPD printer that uses that queue. For instance, if you set up string "a" with a value of "abc" and string "z" with a value of "xyz", you can define print queue "az_queue" with a prepend string of "a", an append string of "z", and a queue type of "raw". Status The Status page displays the current security configuration settings of the print server. The settings that will be displayed depend on the features supported by the print server. ENWW Using the Embedded Web Server 113 Wizard Note If you use HP Web Jetadmin to manage your devices, you should not use this wizard. Instead, use HP Web Jetadmin to configure your network security settings to ensure they are properly set for your network. The Wizard page allows you to run the HP Jetdirect Security Configuration Wizard. This wizard will guide you through the print server's security configuration needed for your network. The optional configuration parameters presented by the wizard will depend on your choice of security level. Note If you improperly exit the wizard (for example, by failing to use the Cancel button), an Operation Failed screen may appear. If so, wait approximately two minutes before entering the wizard again. Restore Defaults This page is used to restore security configuration settings to factory defaults. The default settings displayed depend on the features supported by the print server. Only the security settings listed are restored to factory defaults, other configuration settings are not affected. ENWW Using the Embedded Web Server 114 Table 4. 7 Wizard Security Levels (1 of 2) Description This option requires that you configure an administrator password for configuration management. The administrator password is shared with other management tools, such as Telnet and SNMP applications. However, some management tools, such as Telnet, use plain-text communications and are not secure. [. . . ] 10T FULL: 10 Mbps, full-duplex operation. 100TX HALF: 100 Mbps, half-duplex operation 100TX FULL: 100 Mbps, full-duplex operation ENWW The HP Jetdirect Control Panel Menu 221 C OpenSSL Statements OpenSSL License Copyright © 1998-2004 The OpenSSL Project. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. [. . . ]