User manual HP LASERJET PRO M130A

[. . . ] LaserJet Pro MFP M129-M132, LaserJet Ultra MFP M133-M134 Getting Started Guide Follow Steps 1 - 3 on the printer hardware setup poster, then continue with Step 4. Set up the control panel At the printer control panel, check the display status before beginning software installation. Select a connection method USB connection directly between the  printer and the computer Use an A-to-B type USB cable. To connect the printer to a wireless (Wi-Fi) network, on the printer control panel, touch the Wireless button. [. . . ] Select the printer, which will show up as ‘HP-Print-model-name’ as shown on the printer control panel. Once the printer is connected to a network, enter the printer’s network IP  address into a web browser. Use one of the following options to find the printer IP: • Go to “Find printer IP address, ” in this getting started guide • Refer to the user guide 2. On the web page that appears, click the HP Web Services tab. Review and accept the terms of use, and then click the Enable button. From the Home screen on the printer control panel, touch the Web Services button. The printer enables Web Services, and then prints an information page. The information page contains a printer code necessary to register the HP printer at HP Connected. Com to create an HP ePrint account and complete the setup process. Use HP ePrint via email to print documents by sending them as an email attachment to the printer’s email address from any email enabled device, even from devices that are not on the same network. To use HP ePrint via email, the printer must meet these requirements: • • The printer must be connected to a wired or wireless network and have Internet access. HP Web Services must be enabled on the printer, and the printer must be registered with HP Connected. 1 Set up fax (fax models only - optional) Connect the printer The printer is an analog device. HP recommends using the printer on a dedicated analog telephone line. NOTE: Some countries/regions might require an adapter for the phone cord that came with the printer. Connect the phone cord that came with the printer to the Fax port on the printer and to the telephone jack on the wall. Disconnect the answering machine phone cord from the phone jack, and then connect it to the phone port on the printer. Connect the phone cord that came with the printer to the fax port on the printer and to the telephone jack on the wall. Configuring the fax time, date, and header settings is required to use the fax feature. Click HP, click the name of the printer, and then click Fax Setup Wizard. Follow the on-screen instructions to configure the fax settings. On the printer control panel, press the Setup button. [. . . ] €¢ Verify that the print driver is installed on the computer. €¢ Test the network connection by pinging the network: Windows Click Start > Run. Type ping, type a space, type the printer IP address, and then press Enter. To find the printer IP, see “Find the printer IP address. [. . . ]