User manual HP M5035X

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, correct the interference by one or more of the following measures: · Connect equipment to an outlet on a circuit different from that to Any changes or modifications to the device that are not expressly approved by HP could void the user's authority to operate this equipment. Use of a shielded interface cable is required to comply with the Class A limits of Part 15 of FCC rules. For more regulatory information, see the HP LaserJet 5035MFP electronic user guide. Hewlett-Packard shall not be liable for any direct, indirect, incidental, consequential, or other damage alleged in connection with the furnishing or use of this information. [. . . ] When prompted, connect a USB cable between the device and the computer. Note: HP does not recommend using USB hubs. Use a USB cable that is no longer than 2 meters (6. 24) Place the CD in the CD-ROM drive and run the installer. Note: Install the software before connecting the USB cable. 25) Connect a USB cable between the device and the computer. Note: HP does not recommend using USB hubs. Use a USB cable that is no longer than 2 meters (6. Important: Perform steps 26-30 only if the USB cable was connected before the software was installed. 26) From Apple System Preferences (available in the Apple drop-down menu) click Print & Fax, and then click the Printing tab at the top of the window. 27) To add your device, click the "+" icon to launch the Printer Browser. By default, the Printer Browser displays devices that are connected through USB, Bonjour, and AppleTalk networking. 28) From the Printer Browser window, select the HP device. Note: If HP software is installed, the software should automatically be configured for Macintosh OS X V 10. 29) Click Add to create a printer queue, and then follow the prompt to manually configure the device's installable options. 3 might require you to manually select the printer model from the Printer Model drop-down menu. 30) Under Model Name, select the device, click Add, and go to step 31. 31) Print a page from any program to make sure that the software is correctly installed. Note: If the page failed to print, reinstall the software. If the page fails to print after reinstalling, go to www. 33) Type the device IP address (found on the Jetdirect configuration page). Note: If you are using an Internet Service Provider (ISP) for Internet access and e-mail you might need to contact your ISP to obtain the SMTP server name, and to determine if you need to enter an account name and password for SMTP authentication. [. . . ] Email Gateway Not Responding appears on the control-panel display when attempting to send an e-mail Contact your IT administrator to obtain the correct address. 2) If you are using an Internet Service Provider (ISP) for e-mail, contact your ISP provider the hostname of your SMTP gateway (request the fully qualified domain name (FQDN), not the IP address). 3) Make sure that the entered SMTP authentication user name and password are correct. The "from" address cannot The "Prevent Device User from changing the e-mail address" feature in the be changed in Send to EWS might be selected, or "Device Authentication" is enabled. [. . . ]