User manual HP MP3135

[. . . ] hp mp3130 digital projector user's guide 1 Notice This manual and any examples contained herein are provided "as is" and are subject to change without notice. Hewlett-Packard Company makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard Company shall not be liable for any errors or for incidental or consequential damages in connection with the furnishing, performance, or use of this manual or the examples herein. Consumer transactions in Australia and the United Kingdom: The above disclaimers and limitations shall not apply to consumer transactions in Australia and the United Kingdom and shall not affect the statutory rights of consumers. [. . . ] · If a wide-screen picture seems stretched, select 16:9. · To show each picture dot as one projected dot, select 1-to-1. Reset video settings Resets this menu to default settings. User's Guide 43 Adjusting the Projector Audio menu Audio Mute Volume Treble Bass Reset audio settings Stops the audio output. Changes the loudness of the higher frequencies. Changes the loudness of the lower frequencies. Resets this menu to the default values. Setup menu Setup Language Lamp saver Projector position Selects the language for the menus. Sets a lower light output for longer lamp life. Adjusts the image to match the orientation of the projector: upright or upside-down, in front of or behind the screen. Inverts or reverses the image accordingly. Sets whether slanted edges of an image are automatically corrected. Sets how long the on-screen menu waits for input before it closes. Resets most of the menu settings to default. Auto keystone Timeout for menu Reset lamp hours Reset all settings 44 User's Guide Adjusting the Projector Help menu Help About this projector Diagnostics Displays information and status for the projector. Show tests for checking the operation of the projector and the remote control. User's Guide 45 Adjusting the Projector 46 User's Guide 4 Maintaining the Projector This chapter explains how to maintain the projector. "Performing Routine Maintenance" on page 47 "Upgrading the Projector" on page 51 Performing Routine Maintenance This section provides instructions on performing routing maintenance. "To get the projector status" on page 47 "To clean the projector lens" on page 47 "To replace the lamp module" on page 48 "To replace the battery in the remote control" on page 50 To get the projector status Open the on-screen menu and select Help > About this projector. This screen shows information and status for the projector. To clean the projector lens To minimize the risk of damaging or scratching the lens surface, blow dust particles off the lens with clean, dry, deionized air. Wipe the lens in a single direction with a clean, dry cloth. Do not wipe back and forth across the lens. If the cloth is dirty or smears the lens, wash the cloth. If the cloth is still dirty after washing it or the fabric is damaged, replace it. If this method does not work, use the following method: User's Guide 47 Maintaining the Projector Cleaning requires special consideration: Ä CAUTION:spray any type of fluid or cleaner directly on the lens surface. Do not use fabric softener when washing a cleaning cloth or softener sheets when drying the cloth. Chemicals on the cloth might damage the surface of the lens. Do not store a cleaning cloth in contact with the lens for a long time because doing so contaminates the lens with dye from the cloth. The cloth can be contaminated if left in the open air. To replace the lamp module module Å WARNING: Replacing the lamp of life, it requires special consideration: of injury, When the lamp nears its end might break. [. . . ] Be aware that the beam is invisible light and cannot be seen. Do not attempt to view the infrared LED beam with any type of optical device. Mercury safety This digital projector lamp contains Å WARNING:adequately ventilate the area where a small amount of mercury. If the lamp breaks, the breakage occurred. Disposal of the lamp might be regulated due to environmental considerations. [. . . ]