User manual HP MR4000N

[. . . ] HP MR4000N HDTV Tuner User's Guide Regulatory model: HSTND-3X01 The information in this document is subject to change without notice. Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HP shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. THE WARRANTY TERMS CONTAINED IN THIS STATEMENT, EXCEPT TO THE EXTENT LAWFULLY PERMITTED, DO NOT EXCLUDE, RESTRICT OR MODIFY AND ARE IN ADDITION TO ANY MANDATORY STATUTORY RIGHTS APPLICABLE TO THE SALE OF THIS PRODUCT OR SERVICE TO YOU. [. . . ] Insert two AAA non-rechargeable batteries into the remote control, and ensure that you match them to their proper polarities. 1 Push down the tab and pull back the cover on the back of the remote control. 2 Insert the batteries into the remote control, and make sure that you match polarities. 3 Close the cover. CAUTION: Use only the size and type of batteries specified. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. Do not mix different types of batteries together (e. g. , alkaline and carbon-zinc) or old batteries with fresh ones. When not using the remote for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Do not try to recharge batteries that are not intended to be recharged; they can overheat and rupture. (Follow the battery manufacturer's directions for the batteries you are using. ) Always remove batteries as soon as they become weak. Weak batteries can leak and severely damage the unit. Replace batteries when the remote control operation becomes erratic. Do not take apart the batteries, heat them, or throw them into a fire. Using the Electronic Program Guide (EPG) Use the Electronic Program Guide (EPG) to view the listing of current and future programs. Press the Guide button on your remote control to display the EPG. There are two different styles of the EPG: Current Guide: Displays programs that are currently on air. All Guide: Displays the same information as the Current Guide, plus a schedule of future programs. For information on changing between Current Guide and All Guide, see "Electronic Program Guide (EPG)" on page 21. 10 Using the HP HDTV Tuner Use the arrow buttons on the remote control to scroll through the programs listed in your guide. Highlighting a program gives you the following information: · · · · · · · Time the program begins and ends. Format of the program broadcast (high definition or standard definition). TV rating or MPAA rating of the program. Using the On-Screen Menu The On-Screen Menu (OSM) provides an easy way to customize your HP HDTV Tuner. Use it to customize channels, enable captioning, adjust screen format, and sound. NOTE: When 1080i, 720p, or 480p (DTV) is selected with the Resolution Select switch on the rear panel, the OSM and Electronic Program Guide are not supported for Monitor Out (composite). [. . . ] Follow these steps to set your EPG: 1 Press the Menu button on your remote control. 2 Highlight Setup, and press the Select button. 3 Highlight Program Guide Setting, and press the Select button. 4 Use the arrow buttons to highlight Current Guide or All Guide, and press the Select button. [. . . ]