User manual HP OFFICEJET 5610XI

[. . . ] HP Officejet 5600 All-in-One series User Guide HP Officejet 5600 All-in-One series User Guide © Copyright 2005 Hewlett-Packard Development Company, L. P. The information contained herein is subject to change without notice. Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under copyright laws. ­ ­ ­ Immigration papers Selective service papers Identification badges, cards, or insignias Postage stamps Food stamps Warning This equipment will be inoperable when main power fails. Governmental stamps: ­ ­ Adobe and the Acrobat logo are either registered trademarks or trademarks of Adobe Systems Incorporated in the United States and/or other countries. [. . . ] To send a fax using monitor dialing from the control panel 1. Load your originals, with the print side up, into the document feeder tray. If you are sending a single-page fax, such as a photograph, you can also load your original on the glass. Note If you are sending a multiple-page fax, you must load the originals in the document feeder tray. You cannot fax a multiple-page document from the glass. Press Fax, and then press Start Black or Start Color. ­ If the HP All-in-One detects an original loaded in the automatic document feeder, you will hear a dial tone. ­ If the HP All-in-One does not detect an original loaded in the automatic document feeder, the Fax from glass?Make sure your original is loaded on the glass, and then press 1 to select Yes. Once you hear the dial tone, enter the number by using the keypad on the control panel. Tip If you are using a calling card to send the fax, when prompted to enter your PIN, press Speed Dial or a one-touch speed dial button to select the speed dial entry where you have your PIN stored. Your fax is sent when the receiving fax machine answers. 3. 4. Fax User Guide 67 Chapter 8 Receive a fax Depending on the Auto Answer setting, your HP All-in-One can receive faxes automatically or manually. If you have set the Auto Answer option to Off, you will need to receive faxes manually. If the Auto Answer option is set to On (the default setting), your HP All-in-One will automatically answer incoming calls and receive faxes after the number of rings specified by the Rings to Answer setting. (The default Rings to Answer setting is five rings. ) For more information on Auto Answer, see Set the answer mode. Note If you installed a photo print cartridge for printing photos, you might want to replace it with the black print cartridge when receiving faxes. See Use a photo print cartridge. Receive a fax manually If you set up your HP All-in-One to receive faxes manually (the Auto Answer option is set to Off) or you answer the phone and hear fax tones, use the instructions in this section to receive faxes. Make sure the HP All-in-One is turned on and you have paper loaded in the input tray. Remove any originals from the document feeder tray. If you are currently on the phone with the sender, instruct the sender to press Start on their fax machine. When you hear fax tones from a sending fax machine, do the following: a. [. . . ] This precaution might be particularly important in rural areas. Note The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface might consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5. The REN for this product is 0. 1B, based on FCC Part 68 test results. Notice to users in the European Economic Area This product is designed to be connected to the analog Switched Telecommunication Networks (PSTN) of the European Economic Area (EEA) countries/regions. [. . . ]