User manual HP OFFICEJET 6300 ALL-IN-ONE

[. . . ] HP Officejet 6300 All-in-One series User Guide HP Officejet 6300 All-in-One series User Guide © Copyright 2006 Hewlett-Packard Development Company, L. P. The information contained herein is subject to change without notice. Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under copyright laws. ­ ­ ­ Immigration papers Selective service papers Identification badges, cards, or insignias Postage stamps Food stamps Warning This equipment will be inoperable when main power fails. Governmental stamps: ­ ­ Adobe and the Acrobat logo are either registered trademarks or trademarks of Adobe Systems Incorporated in the United States and/or other countries. [. . . ] To set the HP All-in-One to print fax error reports automatically 1. This selects Print Report and then selects Fax Error Report. Press to select one of the following, and then press OK. Send & Receive Off On Fax Send Prints whenever there is any kind of fax error. Prints whenever there is a transmission error. Fax On Fax Receive Prints whenever there is a receiving error. Stop faxing You can cancel a fax you are sending or receiving at any time. To stop faxing from the control panel Press Cancel on the control panel to stop a fax you are sending or receiving. If the HP All-in-One does not stop faxing, press Cancel again. The HP All-in-One prints any pages it has already started printing and then cancels the remainder of the fax. To cancel a number you are dialing Press Cancel to cancel a number you are currently dialing. 78 HP Officejet 6300 All-in-One series 7 Use the copy features The HP All-in-One enables you to produce high-quality color and black-and-white copies on a variety of paper types, including transparencies. You can enlarge or reduce the size of an original to fit a specific paper size, adjust the darkness of the copy, and use special features to make high-quality copies of photos, including borderless copies. Tip For the best copy performance on standard copy projects, set the paper size to Letter or A4, the paper type to Plain Paper, and the copy quality to Fast. Make a copy Change the copy settings Make a 10 x 15 cm (4 x 6 inch) borderless copy of a photo Stop copying Make a copy You can make quality copies from the control panel. Load multiple-page originals into the document feeder tray. To make a copy from the control panel 1. Make sure you have paper loaded in the input tray. Load your original print side down on the right front corner of the glass or print side up in the document feeder tray. If you use the document feeder tray, place the pages so that the top edge of the document goes in first. Do one of the following: ­ Press Start Copy Black to initiate a black-and-white copy job. ­ Press Start Copy Color to initiate a color copy job. Note If you have a color original, pressing Start Copy Black produces a black-and-white copy of the color original, while pressing Start Copy Color produces a full-color copy of the color original. Copy Change the copy settings You can customize the copy settings of the HP All-in-One to handle nearly any task. When you change copy settings, the changes are for the current copy job only. You must set the changes as defaults for the settings to apply to all future copy jobs. To change the copy settings for the current job only 1. [. . . ] Note The REN assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface might consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5. The REN for this product is 0. 1B, based on FCC Part 68 test results. 154 HP Officejet 6300 All-in-One series Notice to users in Japan VCCI-2 Technical information Notice to users in the European Economic Area This product is designed to be connected to the analog Switched Telecommunication Networks (PSTN) of the European Economic Area (EEA) countries/regions. Network compatibility depends on customer selected settings, which must be reset to use the equipment on a telephone network in a country/region other than where the product was purchased. [. . . ]