User manual HP OFFICEJET 6500 E709A SETUP POSTER

[. . . ] Do not force paper too far into the input tray, or it might cause a paper jam. 2 · HP All-in-One 7 Connect the power cord and adapter IMPORTANT: To ensure that the software is installed correctly, do not connect the USB cable until step 17. 8 a Connect the supplied phone cord a (1-LINE) Connect one end of the supplied phone cord to the phone port (1-LINE) and the other to a wall jack. b (2-EXT) Follow the step below if you want to connect your phone/answering machine to the HP All-in-One. Remove the plug from the (2-EXT) port, and then plug your phone or answering machine cord into the port. [. . . ] See the User Guide if you want to use your own phone cord or if you have any of these features: · DSL · VoIP/FoIP · ISDN · Voice mail · Distinctive ring User Guide b HP Officejet 4300 All-in-One series 9 Press the On button After you press the On button, wait for the print cartridge prompt before continuing. HP All-in-One · 3 10 Open the print cartridge door Lift the print cartridge door. The print carriage moves to the right side. 11 Remove tape from both cartridges Pull the tab to remove the tape from both print cartridges. IMPORTANT: Do not touch copper-colored contacts or retape the cartridges. 12 a Insert the tri-color print cartridge b CAUTION: The device must be On before you can insert the print cartridges. a Slide the tri-color print cartridge into the left slot as shown. b Push the top part of the cartridge firmly up and into the slot until it snaps into place. 4 · HP All-in-One 13 a Insert the black print cartridge b a Slide the black print cartridge into the right slot. b Push the top part of the cartridge firmly up and into the slot until it snaps into place. Close the print cartridge door. 14 a Align the print cartridges a Press OK to print the alignment page. (Make sure you have loaded plain white paper in the bottom tray). b Remove the alignment page from the output tray. After you have cleared the jam, make sure you press the control panel back into place. You may also need to remove any jammed paper from the rear access door or from inside the device. Problem: The Remove and check print cartridges message appears after you insert print cartridges. Make sure you remove all tape from the copper contacts. Re-insert the cartridges, and then close the print cartridge door. Problem: (Windows only) You did not see the screen telling you when to connect the USB cable. Action: Remove and then re-insert the HP All-in-One Windows CD. Refer to Step 16. Problem: (Windows only) The Microsoft Add Hardware screen appears. Unplug the USB cable, and then insert the HP All-in-One Windows CD. [. . . ] Refer to Steps 16 and 17. Problem: (Windows only) The Device Setup Has Failed To Complete screen appears. Action: Verify that the control panel faceplate is firmly attached. Make sure the USB cable is plugged into the computer. [. . . ]