User manual HP OMEN 15-AX202NF

[. . . ] This document is intended for HP authorized service providers only. Bluetooth is a trademark owned by its proprietor and used by Hewlett-Packard Company under license. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. [. . . ] 0 broad head screws (3) that secure the TouchPad to the computer. Reverse this procedure to install the TouchPad. TouchPad 33 System board Component System board equipped with an Intel Core i7-4710 processor (includes thermal grease and thermal pads) Includes 16 GB of system memory and 4 GB of discrete graphics memory for use in models without the Windows operating system Includes 16 GB of system memory and 4 GB of discrete graphics memory for use in models with Windows 8. 1 Standard Includes 16 GB of system memory and 4 GB of discrete graphics memory for use in models with Windows 8. 1 Professional Includes 8 GB of system memory and 4 GB of discrete graphics memory for use in models without the Windows operating system Includes 8 GB of system memory and 4 GB of discrete graphics memory for use in models with Windows 8. 1 Standard Includes 8 GB of system memory and 4 GB of discrete graphics memory for use in models with Windows 8. 1 Professional Includes 8 GB of system memory and 2 GB of discrete graphics memory for use in models without the Windows operating system Includes 8 GB of system memory and 2 GB of discrete graphics memory for use in models with Windows 8. 1 Standard Includes 8 GB of system memory and 2 GB of discrete graphics memory for use in models with Windows 8. 1 Professional 788615-001 788615-501 788615-601 788616-001 788616-501 788616-601 788614-001 788614-501 788614-601 Spare part number Before replacing the system board, follow these steps: 1. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. Disconnect the power from the computer by unplugging the power cord from the computer. disconnect all external devices from the computer. Remove the bottom cover (see Bottom cover on page 23). Disconnect the following cables from the system board. (1): Display cable (2): Left speaker cable (3): Power connector cable (4): Left light assembly (5): TouchPad cable 34 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts (6): Keyboard cable (7): Touch control cable (8): Webcam cable (9): Right speaker cable (10): Right light assembly (11): Power button board cable (12): Light module cable 2. 0 screws (1) that secure the system board to the computer. Remove the bolthead screw (2) that secures the system board to the computer. Lift the system board (3) out of the computer. Reverse this procedure to install the system board. 36 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts Power button board Component Power button board (includes cable) Spare part number 788605-001 Before replacing the power button board, follow these steps: 1. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. Disconnect the power from the computer by unplugging the power cord from the computer. [. . . ] Restore and recovery 55 9 Power cord set requirements The wide-range input feature of the computer permits it to operate from any line voltage from 100 to 120 volts AC, or from 220 to 240 volts AC. The 3-conductor power cord set included with the computer meets the requirements for use in the country or region where the equipment is purchased. Power cord sets for use in other countries and regions must meet the requirements of the country or region where the computer is used. Requirements for all countries The following requirements are applicable to all countries and regions: ● ● ● ● The length of the power cord set must be at least 1. [. . . ]