User manual HP OMNIBOOK 4150

[. . . ] HP OmniBook 4150 User's Handbook Notice This manual and any examples contained herein are provided "as is" and are subject to change without notice. Hewlett-Packard Company makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. shall not be liable for any errors or for incidental or consequential damages in connection with the furnishing, performance, or use of this manual or the examples herein. Consumer transactions in Australia and the United Kingdom: The above disclaimers and limitations shall not apply to Consumer transactions in Australia and the United Kingdom and shall not affect the statutory rights of Consumers. [. . . ] This might include setting switches to configure the equipment so that it will operate properly with the OmniBook and the software you plan to use. To identify connectors for external devices The following picture describes the available connectors for external devices. Refer to it, if necessary, when following the procedures in this section. 1. Use this port for wireless data transmission between the OmniBook and another computer or a printer with an infrared port. In Windows 95, you must install infrared drivers. Kensington lock slot (security connector). Use this port for a parallel printer, other parallel device, or to connect the floppy disk drive externally. Use this port for a serial mouse, a modem, a serial printer, or other serial device. Docking port (for the port replicator or docking system). User's Handbook 53 Expanding the OmniBook Connecting External Devices These additional connectors are available on the left side of the computer: · Universal Serial Bus (USB) port. Use this to connect a keyboard or an external PS/2 mouse. For information about connecting to serial devices, USB devices, audio devices, and infrared devices, see the section "Connecting External Devices" in the online Reference Guide. To connect an external monitor You can connect a VGA, SVGA, XGA, or SXGA monitor to your OmniBook--or UXGA for a computer with "4150 B" after the serial number. The OmniBook's internal display supports standard XGA mode (1024 by 768 pixels). Press the blue power button for one second to suspend the OmniBook. Connect the monitor cable to the monitor, then to the monitor port on the back of the OmniBook. Connect the monitor to a power source and turn it on. Press the blue power button to turn on the OmniBook. If the external monitor has a different resolution from the internal display, adjust the display properties (My Computer, Control Panel, Display, Settings). To enable the built-in and external displays · For a temporary change, press Fn+F5 to cycle through the display options (Internal, External, Both). · For a permanent change in which display is active, change the Video Display Device setting in the BIOS Setup utility (see below). · For a display connected to a video adapter in a docking system, the docking display is automatically selected when it is detected. To change this behavior, change the Primary Video Adapter setting in the BIOS Setup utility (see below). See "To run the BIOS Setup utility" on page 62. 54 User's Handbook Expanding the OmniBook Connecting External Devices To connect an external keyboard or PS/2 mouse The 6-pin PS/2 port allows you to attach an external keyboard or a PS/2-compatible mouse to the OmniBook. While an external PS/2 mouse is connected, the built-in pointing devices are normally disabled. · Plug the mouse or keyboard PS/2 cable into the PS/2 port on the OmniBook. [. . . ] · Do not attempt to make any adjustment of the unit. · Avoid direct eye exposure to the infrared LED beam. Be aware that the beam is invisible light and cannot be seen. · Do not attempt to view the infrared LED beam with any type of optical device. CLASS 1 LED PRODUCT LEDSCHÜTZKLASSE 1 PRODUKT User's Handbook 101 Specifications and Regulatory Information Regulatory Information Regulatory Information This section presents information that shows how the OmniBook complies with regulations in certain regions. [. . . ]