User manual HP OMNIBOOK 600C Supplementary Guide

[. . . ] HP OmniBook 600C/CT Familiarization Guide This guide is for experienced HP Response Center personnel, CEs, and reseller technicians. That is, personnel that have already completed the HP Vectra PC family training course, or equivalent, and have at least six months of experience servicing the HP Vectra PCs. It is a self-paced training guide designed to train you to install configure, and repair the OmniBook Notebook PC. You can follow it without having any equipment available. [. . . ] The Card Eject Button and Spring Eject Flash Card do not need to be removed. Disconnect the speaker wire connector and the ribbon cable from the Paw Mech Assy from the Motherboard. Notice how the Ribbon cable from the Paw Mech Assy is routed. Remove the 6 torx drive screws - T^ drive that hold the Motherboard in place. There are 4 silver torx head screws that hold the two PCMCIA connectors in place on the Motherboard and one additional silver torx drive screw that holds the RAM Expansion connector in place. To remove the Motherboard, lift up on the VGA connector while holding the Keyboard Bottom Case in place. Once the Motherboard has been removed you have access to the Speaker, Paw Mech Assy, Spring Eject Plastic Mouse, Mouse Eject Arm, and Shield. To reassemble, reverse the above procedures. Make sure the Shield is in place and that the ribbon cable from the Paw Mech Assy is properly routed. If the ribbon cable is not properly routed, it will interfere with the installation of the hard disk drive. Small parts The, I/O door, Rubber feet, and Flash card tray are all replaceable. Flex the door so that the center hinge separates from back case. Continue to flex until side pins clear holes in back case. To reassemble, just reverse the procedure. The rubber feet are pressed into the bottom case. To remove, stick a pin into the foot from the side and pull the foot up. To install a new foot, insert into hole and press firmly. The Flash card tray assembly (PCMCIA accessory Tray) is removed and installed in the same manner as the Hard Disk Drive. Installing memory The OmniBook 600 family has one location for expanding system RAM. The memory location is on the front surface of the OmniBook 600. To remove RAM already installed, rotate the pull tab out from under the RAM module and pull the module out. To install a RAM module, use the reverse procedure. Make sure that the pull tab is on the bottom. Ehhanced Port Replicator The Enhanced Port Replicator Accessory consists of no field replaceable components. If any component of the dock is defective, the entire unit must be replaced. Troubleshooting Tips: Power Maintain power to the port replicator. [. . . ] This message indicates that a user pressed the spacebar while the memory tests were nmning and stopped the memory tests. This message indicates that an error was found during POST. Pressing the Fl key allows the system to attempt to boot. A user can stop the memory tests by pressing the spacebar. Press the Fl key to continue Beginning memory test Press the SPACEBAR to terminate the memory test Press the Fl key to continue, F2 to nm the Setup utility This message indicates that an error was found during POST. [. . . ]