User manual HP PAVILION ZT1000-ID

[. . . ] HP Notebook PC Startup Guide Notice This manual and any examples contained herein are provided "as is" and are subject to change without notice. Hewlett-Packard Company makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. shall not be liable for any errors or for incidental or consequential damages in connection with the furnishing, performance, or use of this manual or the examples herein. Consumer transactions in Australia and the United Kingdom: The above disclaimers and limitations shall not apply to Consumer transactions in Australia and the United Kingdom and shall not affect the statutory rights of Consumers. [. . . ] s You' need a small Phillips screwdriver for these procedures. ll To install a RAM expansion module To increase your notebook' RAM, you can install a RAM module in the expansion slot s on the bottom of the notebook. CAUTION Your notebook' chips are extremely sensitive to static electricity, and can be s permanently damaged by it. Handle the RAM module only by its edges. Before installing the memory module, discharge your body' static electricity by touching s the metal shielding around the connectors on the rear of the notebook. Turn off the notebook: click Start, Turn Off Computer, Turn Off. Important: unplug the AC adapter, if present, and remove the battery. From the bottom of the notebook, loosen the screw holding the RAM cover (the cover retains the screw), and remove the cover. Carefully insert the edge of the RAM module into the connector at about a 30° angle until it is fully seated. Then press down on both sides until the latches snap closed. 5. To remove the RAM module, release the two latches at the sides of the module. You can also replace the system RAM module beneath the keyboard-- see "Installing Additional RAM" in the online Reference Guide. 42 Startup Guide Add-On Devices Replacing the Hard Disk Drive Replacing the Hard Disk Drive To replace the hard disk drive You' need a small Phillips screwdriver for this procedure. Unplug the AC adapter, if present, and remove the battery. Remove both hard drive retaining screws from the bottom of the notebook. 3. Carefully pull the hard drive out of the notebook. Gently slide the new drive into the hard drive compartment. Press firmly to make sure the connector seats properly. Reinstall the hard drive retaining screws. Important If you are installing a new hard disk drive, you should create a Utility partition on the drive before loading any software. See "To recover the factory installation of your hard disk" on page 53. If the notebook prompts you to activate Windows XP, follow the instructions that appear onscreen. The Windows XP Product ID code is located on the bottom of the notebook. To install the holder on a new hard disk drive or prepare a new hard disk for use, see "Replacing the Hard Disk Drive" in the online Reference Guide. Note If the notebook prompts you to activate Windows XP, follow the instructions that appear onscreen. [. . . ] +1 (650) 857-1501 Hewlett-Packard Company Notebook PC OmniBook XE3, Pavilion N5D series Notebook PC (D is any digit 0­9) declares that the product Trade name: Product name: Model Number(s): complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Canada This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the radio interference regulations of the Canadian Department of Communications. [. . . ]