User manual HP PAVILION 22XI

[. . . ] 8 cm (20–inch) diagonal viewable area display with 1600 x 900 resolution, plus full-screen support for lower resolutions: includes custom scaling for maximum image size while preserving original aspect ratio 22xi/22bw/20fi models, 54. 5-inch) diagonal viewable area display with 1920 x 1080 resolution, plus full-screen support for lower resolutions; includes custom scaling for maximum image size while preserving original aspect ratio 23xi/23bw/23fi models, 58. 4 cm (23-inch) diagonal viewable area display with 1920 x 1080 resolution, plus full-screen support for lower resolutions; includes custom scaling for maximum image size while preserving original aspect ratio 25xi/25bw model, 63. 5 cm (25-inch) diagonal viewable area display with 1920 x 1080 resolution, plus full-screen support for lower resolutions; includes custom scaling for maximum image size while preserving original aspect ratio 27xi/27bw model, 68. [. . . ] 8 Chapter 2 Setting Up the Monitor Front Panel Controls Figure 2-8 Monitor Front Panel Controls NOTE: The front panel controls on the HP 25xi/25bw and HP 27xi/27bw models are inactive unless they are illuminated. To activate the controls, tap on the area where the icons are located. all icons will become illuminated and active. The backlight for the icons will turn off upon exit from the OSD or when the OSD times out. 3 Quick View/Minus This item can only be used with a VGA input If the OSD menu is on, press to navigate backward through the OSD menu and decrease adjustment levels. If the OSD menu is inactive, press to activate the Quick View button that chooses different settings (HP Enhance+, Movie, Photo, Gaming, Text, Custom) 4 Plus/source If the OSD menu is on, press to navigate forward through the OSD menu and increase adjustment levels. If the OSD menu is inactive, press to activate the source button that chooses the video signal input (VGA, DVI, or HDMI) 5 6 OK Power If the OSD menu is on, press to select the highlighted menu item. Front Panel Controls 9 NOTE: To view an OSD menu simulator, visit the HP Customer Self Repair Services Media Library at http://www. Adjusting the Monitor Tilt the monitor panel forward or backward to set it to a comfortable eye level. Figure 2-9 Tilting the Monitor Turning on the Monitor 1. Press the power button on the front of the monitor to turn it on. Press the power button on the computer to turn it on. CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a prolonged period of time. * To avoid burn-in image damage on the monitor screen, you should always activate a screen saver application or turn off the monitor when it is not in use for a prolonged period of time. image retention is a condition that may occur on all LCD screens. Monitors with a “burned-in image” are not covered under the HP warranty. * A prolonged period of time is 12 consecutive hours of non-use. NOTE: If pressing the power button has no effect, the Power Button Lockout feature may be enabled. To disable this feature, press and hold the monitor power button for 10 seconds. NOTE: You can disable the power LED in the OSD menu. Press the Menu button on the front of the monitor, then select Management > Bezel Power LED > Off. When the monitor is powered on, a Monitor Status message is displayed for five seconds. [. . . ] 22 Appendix A Technical Specifications Energy Saver Feature The monitors support a reduced power state. The reduced power state will be entered into if the monitor detects the absence of either the horizontal sync signal and/or the vertical sync signal. Upon detecting the absence of these signals, the monitor screen is blanked, the backlight is turned off, and the power light is turned amber. When the monitor is in the reduced power state, the monitor will utilize 0. [. . . ]