User manual HP PAVILION 7770 CD DRIVE

[. . . ] For external speakers, connect a stereo adapter to split the output into separate cables for the left and right channels. Such adapters convert a male stereo mini-jack to two female phono jacks. volume control: Use the volume control to adjust the volume. [. . . ] If you have an IDE CD-ROM/ DVD drive installed in your system, skip step 4 and continue with Step 5. If you have a SCSI CD-ROM drive or no IDE CD-ROM/DVD drive installed on your system, do the following: 4a) Confirm that the jumper on the rear panel of the CD-RW drive is configured to its default setting of Master. 4b) Slide the CD-RW drive into the empty 5. 25-inch drive bay. Install the CDRW drive in your personal computer in a horizontal orientation (within ±10° of horizontal). The eject button should be located on the right side of the unit. Secure the drive using 3x5mm mounting screws. Warning: Do not use mounting screws longer than 3x5mm to secure the CD-RW drive or you may damage the unit. secure drive with 3x5mm screws 4c) Locate the secondary IDE connector on your system's motherboard and connect one end of the IDE interface cable. Be certain to connect Pin-1 of the interface cable to Pin-1 on the secondary IDE connector on the motherboard. (Pin-1 on interface cable is usually designated by a color strip along one edge of the cable. Also, the interface ribbon cable connector may feature a tab on one side. Insert the cable so that the tab aligns with the notch on the interface connector. Do not use excessive force while trying to insert the cable into position). TEAC CD-RW Installation Guide 4 Installing the CD-RW Drive 4d) Connect the opposite end of the interface ribbon cable to the interface connector on the rear panel of the CD-RW drive. AUD IO O UT audio cable IDE INTE RFA CE DC IN notch PUT FG power cable pin 1 IDE interface ribbon cable tab 4e) Connect one end of an analog audio cable to the analog audio connector on the rear panel of the CD-RW drive and connect the opposite end to your sound card. If you have an IDE CD-ROM/DVD drive installed on your system, do the following: Typically, your IDE CD-ROM/DVD drive is connected to the secondary IDE motherboard connector as a Master. In such cases, it is strongly recommended that you connect the CD-RW drive as a Slave drive to the same cable that currently hosts your CD-ROM/DVD drive. 5a) Set the jumper on the rear panel of the CD-RW drive to Slave. 5b) Slide the CD-RW drive into the empty 5. 25-inch drive bay. Install the CDRW drive in your personal computer in a horizontal orientation (within ±10° of horizontal). The eject button should be located on the right side of the unit. [. . . ] The premastering software is to be purchased separately. · · · Recommended Software Before you can record data onto CD-R or CD-RW discs using your TEAC CD-RW Drive, you must first install pre-mastering or packet-writing software onto your computer's hard disk. TEAC recommends the following applications for Windows 95/98/Me/2000-Professional and NT: Adaptec Easy CD Creator, Version 4. 02d or higher: A full-featured premastering software application that enables you to create audio CDs and data CDs. Adaptec DirectCD, Version 3. 01d or higher: A "drag & drop" software application that allows you to read and write to your CD-RW as if it were a standard floppy or removable hard drive. [. . . ]