User manual HP PE4240N

[. . . ] HP PE4240n 42" Plasma Television User's Guide The information in this document is subject to change without notice. Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HP shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. THE WARRANTY TERMS CONTAINED IN THIS STATEMENT, EXCEPT TO THE EXTENT LAWFULLY PERMITTED, DO NOT EXCLUDE, RESTRICT OR MODIFY AND ARE IN ADDITION TO ANY MANDATORY STATUTORY RIGHTS APPLICABLE TO THE SALE OF THIS PRODUCT OR SERVICE TO YOU. [. . . ] · Choose the AV button when you've connected the TV to the HP MCPC as a TV using the Video or S-video inputs. · Choose the Comp button when you've connected the TV to the HP MCPC as a TV using the Component Video inputs. 3 Press HP. PC button (B) on the remote control to select the HP MCPC as the controlled device. 4 Point the remote control at the HP MCPC remote control sensor and press the buttons you want to use. The remote control buttons, such as the guide, channel, volume, and cursor buttons, function along with the special HP MCPC buttons (C through H) described in the table. Set Up 21 TV remote button A B AV, COMP, or DVI/VGA HP. PC HP MCPC button function Selects the TV input source for the main screen Selects the HP MCPC as the device controlled by the remote control. Start Back OK Record Replay Skip C D E F G H HP. MC Back (Exit) Enter PIP Input Replay/Reverse Skip/Forward 22 Set Up Installing or Replacing Remote Control Batteries When the batteries are low, the red light on the remote control blinks twice when a button is pushed. Insert two AA non-rechargeable batteries into the remote control ensuring that you place them with the proper polarity. 1 Press and open the cover on the back of the remote control. 2 Insert the batteries into the remote control, and make sure that you match polarities. 3 Close the cover. CAUTION: Use only the size and type of batteries specified. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. Do not mix different types of batteries together (e. g. , alkaline and carbon-zinc) or old batteries with fresh ones. When not using the remote for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Do not try to recharge batteries that are not intended to be recharged; they can overheat and rupture. (Follow the battery manufacturer's directions for the batteries you are using. ) Always remove batteries as soon as they become weak. Weak batteries can leak and severely damage the unit. The battery life depends on how much the remote control is used. Replace batteries when remote control operation becomes erratic. Do not take apart the batteries, heat them, or throw them into a fire. Set Up 23 Using the TV Front Panel Buttons 1 Power button 2 Power/standby indicator 3 Remote control sensor window 4 Input button 5 Menu button 6 Setting 7 ADJ. +, ADJ­/VOL+, VOL­ 8 CH+, CH­ 24 Using the TV Basic Operations Turning on the TV 1 Plug the power cord (B) into an active AC power outlet. The Power/standby indicator light (2) on the front panel flashes until the power is completely on; then the light is solid red. NOTE: The main power switch (A, see the following figure) (beneath the display panel on the back of the TV) is in the On position from the factory. If the Power/standby indicator light is off after you plug in the TV, the main power switch is off. [. . . ] Is the screen size adjustment appropriate?Is the external device or computer resolution setting appropriate?The horizontal or vertical sync signal is not present when the Intelligent Power Manager control is on. Did the TV turn off 5 seconds after you turned it on? Adjust the screen settings. [. . . ]