User manual HP PHOTOSMART 912

[. . . ] If more than one power cord is in the box, use the cord that is appropriate for power outlets in your country. Plug the other end of the power cord into an electrical outlet. Attach the thin cord from the AC adapter to the power adapter connector on the side of the camera as shown. The Power/Memory light on the back of the camera will start blinking to show that the battery is charging. [. . . ] Repeat Steps 2 and 3 until the date and time are set correctly. Press the button when you have entered the proper values for the date and time. A confirmation screen appears, asking if the correct date and time have been set. Your camera contains internal memory that allows you to store images and video clips. However, you can use a memory card (purchased separately) instead to store images and video clips. Turn off the camera and open the Battery/Memory card door on the bottom of the camera. Insert the memory card in the small slot above the battery, with the notched side of the card going in first, as shown. Make sure the memory card snaps into place. Close the Battery/Memory card door and turn on the camera. To help prevent corrupted cards and images, you should format memory cards before you use them for the first time. Press the button, then use the button to move to the Playback Menu . If you have trouble installing or using the HP Image Zone software, see the HP Customer Support website for more information: www. Close all programs and temporarily disable any virus protection software running on your computer. Insert the HP Image Zone software CD into the CD Drive of your computer and follow the on-screen instructions. If the installation window does not appear, click Start, click Run, type D:\Setup. Exe, where D is the letter of your CD drive, then click OK. When the HP Image Zone software has finished installing, re-enable any virus protection software that you disabled in Step 1. Close all programs and temporarily disable any virus protection software running on your computer. Insert the HP Image Zone software CD into the CD drive of your computer. When the HP Image Zone software has finished installing, re-enable the virus protection software that you disabled in Step 1. Turn off the camera, then connect the camera to the computer either through the USB cable provided or through the optional HP Photosmart R-series dock (see NOTE below). If using the USB cable, turn on the camera. [. . . ] In the HP Instant Share Setup program, click Start, then simply follow the onscreen instructions to set up destinations on the computer and save them to your camera. Click Continue, then simply follow the on-screen instructions to set up destinations on the computer and save them to your camera. Disconnect the camera from the computer, then go back to the HP Instant Share Menu to check that the new destinations are now in the camera. You can now mark images in the camera to be sent to one or more of these HP Instant Share destinations. [. . . ]