User manual HP PHOTOSMART A717

[. . . ] HP Photosmart A710 series User Guide Copyrights and trademarks © 2006 Hewlett-Packard Development Company, L. P. Other brands and their products are trademarks or registered trademarks of their respective holders. Hewlett-Packard Company notices The information contained in this document is subject to change without notice. Reproduction, adaptation, or translation of this material is prohibited without prior written permission of Hewlett-Packard, except as allowed under copyright laws. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] Touching the ink nozzle plate will result in clogs, ink failure, and bad electrical connections. Repeat steps 4 and 5 until no ink residue or dust appears on a clean swab. Insert the print cartridge in the printer, and then close the print cartridge door. Print a test page Print a test page before contacting HP support. The test page contains diagnostic information you can use when working with HP support to solve printing problems. Look at the ink nozzle pattern on the test page to check the ink level and condition of the print 42 HP Photosmart A710 series cartridge. If any line or color is missing from the pattern, try cleaning the print cartridge. For more information, see Automatically clean the print cartridge. Load paper so the printer can print a test page. Use plain paper or index cards to conserve photo paper. Select Test & Sample Pages, and then press OK. Press OK to begin printing the test page. The test page contains the following information: Align the print cartridge The first time you install a print cartridge in the printer, the printer aligns it automatically. However, if colors in the printouts are misaligned, or if the alignment page does not print correctly when you install a new print cartridge, use the following procedure to align the print cartridge. Load HP Advanced Photo Paper in the input tray. Select Align cartridge, and then press OK. HP Photosmart A710 series User Guide 43 Chapter 7 6. 7. Following the directions on the printer screen, load HP Advanced Photo Paper so the printer can print an alignment page. Use plain paper or index cards to conserve photo paper. Press OK to begin aligning the print cartridge. When the printer finishes aligning the cartridge, it prints an alignment page to confirm that the alignment was successful. ­ ­ The check marks verify that the print cartridge is installed correctly and functioning properly. If an "x" appears to the left of any of the bars, align the print cartridge again. If the "x" still appears, replace the print cartridge. Store the printer and print cartridge Protect the printer and print cartridges by storing them properly when you are not using them. Store the printer The printer is built to withstand long or short periods of inactivity. Close the input and output trays and push the printer screen down into the flat position when the printer is not in use. Store the printer indoors out of direct sunlight in a place without temperature extremes. [. . . ] Select Date/time, Date only, or Off (default). Colorspace: Select to choose a colorspace (a three-dimensional mathematical model for organizing color). The colorspace you select affects the colors in your printed photos. Select Adobe RGB, sRGB, or Auto-select (default). [. . . ]