User manual HP PHOTOSMART PROB9180

[. . . ] HP Photosmart Pro B9100 series User Guide Copyrights and trademarks © 2006 Hewlett-Packard Development Company, L. P. Hewlett-Packard Company notices The information contained in this document is subject to change without notice. Reproduction, adaptation, or translation of this material is prohibited without prior written permission of Hewlett-Packard, except as allowed under copyright laws. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] To do this, raise the fold-down blue handle on the printhead, and use it to pull the printhead straight out of its slot. Shake the new printhead vigorously, at least six times, before opening the package. 6. Lift out the printhead. Be careful not to touch the gold-colored contacts on the printhead. In particular, guard against scratching the contacts with your fingernails. HP Photosmart Pro B9100 series User Guide 37 Chapter 4 7. Remove and discard the orange protective covers from the printhead. Do not touch the gold-colored contacts on the printhead. 8. 9. Open the pre-moistened swab included inside the printhead package. Wipe the printhead nozzles with the foam tip of the swab. Wipe along the length of the nozzles at least 3 times. 10. Insert the new printhead into its color-coded stall in the orientation shown. Press straight down on the printhead until it is all the way in. The printhead is designed to insert in only one direction. 38 HP Photosmart Pro B9100 series printer 11. Lower the open printhead assembly cover so that it clips under the metal bar, and then fold the cover back down to its original position. The printer automatically performs printhead alignment and color calibration. Make sure that you have loaded HP Advanced Photo Paper - Glossy in the main tray, and then click OK to perform the alignment and calibration. For information about alignment and calibration, see Align and calibrate the printer. Clean the printer For best results, keep the outside of the printer clean. If you notice any ink residue on the outside of the printer, be sure to clean it off using the following steps. Note Never clean the inside of the printer. Clean the printer To clean the outside of the printer 1. Turn off the printer by pressing the On button. Wipe the outside of the printer with a soft cloth that has been lightly moistened with water. Be sure to wipe away any ink residue that has accumulated on the output tray. Caution Do not use any type of cleaning solution. Household cleaners and detergents might damage the printer finish. [. . . ] Type a unique name (63 characters or less) in the mDNS Service Name box. Select the printer in the Print dialog box. If the printer does not appear in the list, select Edit Printer List to add the printer. 5. HP Photosmart Pro B9100 series User Guide 63 Appendix A 10. [. . . ]