User manual HP PHOTOSMART 6221 PREMIUM CAMERA DOCK

[. . . ] HP Photosmart 6221 Premium Camera Dock User Guide HP Photosmart 6221 Premium Camera Dock User Guide © Copyright 2006 Hewlett-Packard Development Company, L. P. The information contained herein is subject to change without notice. Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under copyright laws. Publication number: Q6221-90108 8. Use only with the power adapter supplied by HP. [. . . ] Rotate button Back button This button takes you out of the camera menus and returns to the previous place. These buttons work just like the arrow buttons on your camera. Use the buttons to navigate through the slide show. Since you can view the camera menus on the TV, you can use these buttons to navigate menus. Works just like the OK button on your camera. buttons OK button Setup button When Press to connect appears on the Image Display, press OK on the remote. Launches the Setup menu on the camera. and 10 HP Photosmart 6221 Premium Camera Dock 4 Technical information Please refer to your camera electronic User Guide for support procedures and contact information. Technical support Troubleshooting Note For additional troubleshooting information, please see the Troubleshooting section in your camera electronic User Guide. Problem The camera batteries will not charge, and the camera charging light is on. Possible cause Batteries in the camera are not rechargeable. The camera has not been left in the dock long enough. Solution Install rechargeable batteries (either Lithium Ion or NiMH as required by your camera). Make sure the camera has been left in the camera dock for at least 4 to 6 hours to charge completely, and the charging light has stopped blinking. The camera will not attempt to charge batteries that may be damaged or overdischarged. If the battery will not charge sufficiently, it is likely that the battery is bad. Purchase new rechargeable batteries and try again. Make sure the camera is inserted completely into the dock. Confirm that the power cord is plugged into the dock. Check that the dock power light blinks when the camera is in the dock. Connect the USB cable directly to one of the USB ports on the computer. If your camera has a USB connector, try connecting the camera directly to the computer using the cable that Battery voltage is too low for charging to start. The camera batteries will not charge, and the camera charging light is off. The camera is not securely in the dock. The camera dock does not have electrical power. The camera is not recognized by the computer when it is in the dock. The dock is connected to the computer through a USB hub or the USB port on the front of the computer. The USB cable connecting the dock to the computer is bad. User Guide 11 Chapter 4 (continued) Problem Possible cause Solution is connecting the dock to the computer. [. . . ] For example, some states in the United States, as well as some governments outside the United States (including provinces in Canada), may: a. Preclude the disclaimers and limitations in this Warranty Statement from limiting the statutory rights of a consumer (e. g. , the United Kingdom); b. Otherwise restrict the ability of a manufacturer to enforce such disclaimers or limitations; or c. Grant the customer additional warranty rights, specify the duration of implied warranties which the manufacturer cannot disclaim, or allow limitations on the duration of implied warranties. [. . . ]