User manual HP PROCURVE MSM460

[. . . ] Hewlett-Packard Company shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is provided "as is" without warranty of any kind and is subject to change without notice. The warranties for HP products are set forth in the express limited warranty statements accompanying such products. Nothing herein should be construed as constituting an additional warranty. [. . . ] In the VID field, type the VID number of the VLAN to which the MAC address belongs. In the MAC Address field, type the MAC address from which packets will be statically filtered. In the Type field, select the filter type, either Permanent or DeleteOnReset. In the Allow-to-Go-Port field, select the port on which the MAC address resides. Click Apply after making changes to the settings. IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM using the Save Changes option on the Maintenance menu. Refer to the section, "Saving Changes, " earlier in this chapter. Adding Multicast Filtering To add multicast filter actions: 1. Select Multicast Filtering from the Static Filtering Table menu. The following screen is displayed. 2. In the MAC Address field, type the MAC address of the static source of multicast packets. In the VID field, type the VID number of the VLAN to which the MAC address belongs. In the Type field, select the filter type, either Permanent or DeleteOnReset. Characteristics of DEFAULT_VLAN include: · · · · · · · · DEFAULT_VLAN is an IEEE 802. 1Q Static VLAN with VID equal to 1. The VID that is equal to 1 is reserved for DEFAULT_VLAN. The VLAN name can be changed to any other valid VLAN name. You cannot delete a port from DEFAULT_VLAN, unless it is a member of another 802. 1Q VLAN. You cannot forbid a port from DEFAULT_VLAN, unless it is a member of another 802. 1Q VLAN. If a port is deleted from the only 802. 1Q VLAN of which it is a member, then it will automatically become a member of DEFAULT_VLAN as an untagged, egress port. If a port is assigned to a user-created 802. 1Q VLAN, and is not a tagged egress port member of DEFAULT_VLAN (in other words, it is an untagged egress port), then it will be deleted automatically from DEFAULT_VLAN. A tagged egress port of DEFAULT_VLAN will not be deleted from DEFAULT_VLAN, when it is assigned to another user-created 802. 1Q VLAN. · To configure a VLAN: 1. Select Static VLAN Entry from the VLAN menu. The following screen is displayed The 802. 1Q Static VLANs window allows you to create or delete entries to the 802. 1Q Static VLAN table. To add an entry to this table, click Add and then fill in the appropriate information in the following window. [. . . ] Type the TFTP server port number in the TFTP Server Port Number field. Type the complete path and file name of the firmware file for the switch module in the File Name field. Click Apply to save the TFTP server IP address, TFTP server port number, and file name into the switch module RAM. Click Start to initiate the file transfer. 2-66 HP ProLiant BL e-Class C-GbE Interconnect Switch Web-based Interface Reference Guide HP CONFIDENTIAL Codename: DeLorean Part Number: 322859-001 Last Saved On: 2/5/03 9:29 AM Configuring the Switch Modules using the Web-based Interface Displaying Switch Module History The switch module can record event information to its own logs, to designated SNMP trap receiving stations, and to the PC connected to the console manager. [. . . ]