User manual HP PROLIANT DL320 G3 SERVER

[. . . ] HP ProLiant DL320 Generation 3 Server User Guide March 2005 (Second Edition) Part Number 374263-002 © Copyright 2004, 2005 Hewlett-Packard Development Company, L. P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] Reconnect the power cable and the two-device SCSI cable to the hard drive. 8. Install a PCI SCSI Array Controller ("Installing a PCI SCSI array controller or a PCI SCSI controller" on page 45). NOTE: HP recommends the 64-Bit/133-MHz Single Channel Ultra320 SCSI HBA G2 SCSI controller be installed in the the low profile slot. 9. Replace the access panel ("Removing the access panel" on page 21). Hardware options installation 43 Installing the CD-ROM drive assembly CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with either a component or a blank. NOTE: The server supports slimline optical devices, including CD-ROM and DVD-ROM. 1. Access the internal server components ("Preparation procedures" on page 20). Remove the fan assembly ("Removing the fan assembly" on page 25). Remove the optical drive assembly by loosening the thumbscrew and sliding the cage out. 44 HP ProLiant DL320 Generation 3 Server User Guide 4. Press the latch release tabs and remove the blank. 5. Install the CD-ROM drive into the optical drive cage with the screws preinstalled on the cage. Hardware options installation 45 6. Install the optical drive assembly in the empty bay, and reinstall the thumbscrew. 7. Install the fan assembly ("Installing the fan assembly" on page 26). Installing the DVD-ROM drive assembly To install an optional DVD-ROM drive assembly, follow the instructions for installing a CD-ROM drive assembly ("Installing the CD-ROM drive assembly" on page 43). Installing the diskette drive assembly To install an optional diskette drive assembly, follow the instructions for installing a CD-ROM drive assembly ("Installing the CD-ROM drive assembly" on page 43). Installing a PCI SCSI array controller or a PCI SCSI controller IMPORTANT: For additional installation and configuration information, refer to the documentation that ships with the option. 46 HP ProLiant DL320 Generation 3 Server User Guide 1. Access the internal server components ("Preparation procedures" on page 20). Remove the PCI riser board assembly ("Removing the PCI riser board assembly" on page 22). Disconnect the SCSI cables from the SCSI connectors on the system board and SCSI drives and remove the cables, if installed. Route the PCI SCSI array controller cables under the PCI riser board assembly. Install the PCI-X or PCI Express riser board assembly. IMPORTANT: The server will not power up if the PCI riser board assembly is not seated properly. 7. Verify proper cable routing with the following illustration. 47 Server cabling In this section Cabling overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47 Server cable routing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47 SATA cable routing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 SCSI cable routing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49 Cabling overview This section provides guidelines that help you make informed decisions about cabling the server and hardware options to optimize performance. For information on cabling peripheral components, refer to the white paper on high-density deployment at the HP website (http://www. hp. com/products/servers/platforms). Server cable routing CAUTION: When routing cables, always be sure that the cables are not in a position where they can be pinched or air flow can be blocked. 48 HP ProLiant DL320 Generation 3 Server User Guide IMPORTANT: Route the cables without blocking the airflow or other installed components. Use the cable clips installed in the chassis to manage cable routing. SATA cable routing CAUTION: When routing cables, always be sure that the cables are not in a position where they can be pinched or air flow can be blocked. Server cabling 49 SCSI cable routing CAUTION: When routing cables, always be sure that the cables are not in a position where they can be pinched or air flow can be blocked. 51 Server software and configuration utilities In this section Configuration tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51 Management tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56 Diagnostic tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63 Keeping the system current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 Configuration tools List of tools: SmartStart software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51 HP ROM-Based Setup Utility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53 Array Configuration Utility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 HP ProLiant Essentials Rapid Deployment Pack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 Re-entering the server serial number and product ID. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 SmartStart software SmartStart is a collection of software that optimizes single-server setup, providing a simple and consistent way to deploy server configuration. SmartStart has been tested on many ProLiant server products, resulting in proven, reliable configurations. SmartStart assists the deployment process by performing a wide range of configuration activities, including: · · · Configuring hardware using embedded configuration utilities, such as RBSU and ORCA Preparing the system for installing "off-the-shelf" versions of leading operating system software Installing optimized server drivers, management agents, and utilities automatically with every assisted installation 52 HP ProLiant DL320 Generation 3 Server User Guide · · Testing server hardware using the Insight Diagnostics Utility ("HP Insight Diagnostics" on page 64) Installing software drivers directly from the CD. With systems that have internet connection, the SmartStart Autorun Menu provides access to a complete list of ProLiant system software. [. . . ] Compliance is mandatory for products marketed in the United States. Battery replacement notice WARNING: The computer contains an internal lithium manganese dioxide, a vanadium pentoxide, or an alkaline battery pack. A risk of fire and burns exists if the battery pack is not properly handled. To reduce the risk of personal injury: · · · Do not attempt to recharge the battery. Do not expose the battery to temperatures higher than 60°C (140°F). [. . . ]