User manual HP PROLIANT DL380 G3 SERVER

[. . . ] HP ProLiant DL380 Generation 3 Server User Guide July 2003 (Third Edition) Part Number 303130-003 © 2003 Hewlett-Packard Development Company, L. P. Microsoft, MS-DOS, Windows, and Windows NT are trademarks of Microsoft Corporation in the U. S. Intel and Xeon are trademarks of Intel Corporation in the U. S. Hewlett-Packard Company shall not be liable for technical or editorial errors or omissions contained herein. [. . . ] Remove the protective cover from the connector pins on the power supply. WARNING: To reduce the risk of electric shock or damage to the equipment, do not connect the power cord to the power supply until the power supply is installed. 4. Slide the power supply into the power supply bay. 86 HP ProLiant DL380 Generation 3 Server User Guide 5. Connect the power cord to the power supply. Route the power cord through the cable management arm or power cord anchor. NOTE: If using the power cord anchor, be sure to leave enough slack in the power cord so that the redundant power supply can be removed without disconnecting the power cord from the primary power supply. 7. Lock the cable management arm into the operating position. Connect the power cord to the power source. Be sure that the power supply LED is green ("Rear Panel LEDs and Buttons" on page 15). Be sure that the front panel external health LED is green ("Front Panel LEDs and Buttons" on page 11). Hardware Options Installation 87 DC Power Supply Option WARNING: A risk of personal injury from electric shock and hazardous energy levels exists. The installation of options and routine maintenance and service of this product must be performed by individuals who are knowledgeable about the procedures, precautions, and hazards associated with DC power products. WARNING: To reduce the risk of electric shock, fire, and damage to the equipment, this product must be installed in accordance with the following guidelines: · · This power supply is intended only for installation in HP servers located in a restricted access location. This power supply is not intended for direct connection to the DC supply branch circuit. It should only be connected to a power distribution unit (PDU) that provides an independent overcurrent-protected output for each DC power supply. Each output overcurrent-protected device in the PDU must be suitable for interrupting fault current available from the DC power source and must be rated no more than 20A. This power supply is designed to be connected only to a DC power source that can be classified as SELV or TNV, in accordance with applicable national requirements for Information Technology Equipment and Telecommunications Equipment. Generally, these requirements are based on the International Standard for Information Technology Equipment, IEC 60950, and/or the European Telecommunication Standard ETS 300 132-2. The DC source is to have one pole (Neutral/Return) reliably connected to earth ground in accordance with local/regional electric codes and/or regulations. The green/yellow lead of the power cable assembly must be connected to a suitable ground/earth terminal located within the rack or cabinet. This terminal must be connected to a suitable building ground/earth terminal in accordance with local/regional electric codes/regulations. Do not rely on the rack or cabinet chassis to provide adequate ground/earth continuity. · · To install a DC power supply: 88 HP ProLiant DL380 Generation 3 Server User Guide 1. Unlock the hinge on the cable management arm and swing the arm away from the server. 2. Identify the power supply configuration: - If AC power supplies are installed, power down the server, disconnect power cables from the back of the server, and continue with the next step. If replacing a non-redundant DC power supply, power down the server, disconnect the power cable from the back of the server, and then skip to step 6. If adding a redundant DC power supply, continue with the next step. [. . . ] Keep electrostatic-sensitive parts in their containers until they arrive at staticfree workstations. Place parts on a grounded surface before removing them from their containers. Avoid touching pins, leads, or circuitry. Always be properly grounded when touching a static-sensitive component or assembly. 152 HP ProLiant DL380 Generation 3 Server User Guide Grounding Methods to Prevent Electrostatic Discharge Several methods are used for grounding. [. . . ]