User manual HP PSC 1311

[. . . ] Note: Regulatory information can be found in the "Technical information" section of this guide. To prevent fire or shock hazard, do not expose this product to rain or any type of moisture. Always follow basic safety precautions when using this product to reduce risk of injury from fire or electric shock. It is not lawful in many places to make copies of the following items. [. . . ] For more information about making changes to an image during the preview, see adjust an image during the preview in scan pictures and documents in the HP Photo & Imaging Help for more information. the HP PSC does a final scan of the original and sends the image to the HP Photo & Imaging Gallery. See manage images in how to use the software for more information about using the HP Photo & Imaging Gallery. To scan an original from your Macintosh computer 1 Load your original on the glass. For more information, see load originals on page 7. If you prefer to scan your document to a software program other than the HP Photo & Imaging Gallery or HP Imaging Center, you can choose a different program from the Scan To list that appears in the front-panel display. For more information, see load originals on page 7. Press to scroll through the Scan To list until the desired scan-to software program appears. You can stop a scan by pressing the Cancel button located on the front panel. This section provides instructions for keeping your HP PSC in top working condition. Dirty glass, from fingerprints, smudges, hair, and so on, slows down performance and affects the accuracy of features such as Fit to Page and Copy. Whenever you remove a print cartridge from the printer, store it in the print cartridge protector that came with your printer. â· To insert a print cartridge into the print cartridge protector, slide the print cartridge into the print cartridge protector at a slight angle and snap it securely into place. To remove the print cartridge from the print cartridge protector, press down and back on the top of the print cartridge protector to release the print cartridge, then slide the print cartridge out of the print cartridge protector. Front-panel display messages appear to let you know that you should replace your print cartridges. You may also need to replace a print cartridge when you want to use the photo print cartridge for printing high-quality photos. Turn on the unit, then open the print-carriage access door by lifting the handle until the door locks into place. After the carriage stops moving, lift the latch to release the print cartridge, then pull it toward you out of its slot. If you are removing the black print cartridge in order to install the photo print cartridge, store it in the print cartridge protector. Remove the new print cartridge from its packaging and, being careful to touch only the black plastic, gently remove the plastic tape. Push the new print cartridge into the appropriate slot until it clicks into place. The tri-color print cartridge goes on the left and the black or photo print cartridge goes on the right. [. . . ] For any hardware Product, the use of a non-HP ink cartridge or a refilled ink cartridge does not affect either the warranty to the Customer or any HP support contract with the Customer. However, if Product failure or damage is attributable to the use of a non-HP or refilled ink cartridge, HP shall charge its standard labor and materials charges to service the Product for the failure or damage. If HP receives, during the applicable warranty period, notice of a defect in any Product, HP shall either repair or replace the defective Product, at HP's option. Where labor charges are not covered by HP's limited warranty, repairs shall be at HP's standard charges for labor. [. . . ]