User manual HP PSC 1410V

[. . . ] HP PSC 1400 All-in-One series User Guide Legal Information © Copyright 2005 Hewlett-Packard Development Company, L. P. The information contained herein is subject to change without notice. Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under copyright laws. The Hewlett-Packard Company shall not be liable for incidental or consequential damages in connection with, or arising out of the furnishing, performance, or use of this document and the program material which it describes. [. . . ] ­ If more than a few lines in a pattern are broken, this might indicate a problem with the nozzles. You might need to clean the print cartridges. For more information, see Clean the print cartridges. If the black line is missing, faded, streaked, or shows lines, this might indicate a problem with the black print cartridge in the right slot. If any of the color lines are missing, faded, streaked, or show lines, this might indicate a problem with the tri-color print cartridge in the left slot. ­ ­ Streaks might indicate clogged nozzles or dirty contacts. You might need to clean the print cartridges. For more information, see Clean the print cartridges. Maintain your HP All-in-One Note For examples of test patterns, lines of color, and color blocks from normal and malfunctioning print cartridges, see the onscreen HP Image Zone Help that came with your software. Work with print cartridges To ensure the best print quality from your HP All-in-One, you will need to perform some simple maintenance procedures. You might also need to check your print cartridges if the Check Print Cartridge light is on. Replace the print cartridges When the ink level for the print cartridge is low, replace the print cartridge. Make sure you have a replacement print cartridge available before removing the empty print cartridge. You should also 30 HP PSC 1400 All-in-One series replace the print cartridges when you see faded text or if you experience print quality issues related to the print cartridges. For information on checking the ink levels from the HP Solution Center or the HP Image Zone, see Check the estimated ink levels. To find out the reorder number for all the print cartridges that your HP All-in-One supports, see Order print cartridges. To order print cartridges for your HP All-in-One, go to www. hp. com. Make sure the HP All-in-One is on and paper is loaded. Caution The HP All-in-One must be on when you lower the print-carriage access door in order to release the cartridges for changing. You might damage the HP All-in-One if the print cartridges are not docked safely in the center when you try to remove them. Lightly press down on a print cartridge to release it and pull it toward you. Note The HP Inkjet Supplies Recycling Program is available in many countries/ regions, and lets you recycle used print cartridges free of charge. For more information, go to the following website: www. hp. com/hpinfo/globalcitizenship/ environment/recycle/inkjet. html 1 2 Tri-color print cartridge slot Black print cartridge slot Remove the new cartridge from its packaging, and being careful to touch only the black plastic, gently remove the plastic tape by using the pink pull tab. Caution Do not touch the copper-colored contacts or ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections. 1 2 3 Caution Do not touch the copper-colored contacts. Maintain your HP All-in-One Plastic tape with pink pull tab (must be removed before installing) Caution tape. Do not touch the ink nozzles under the User Guide 31 Chapter 8 Slide the new print cartridge forward at a slight upward angle into the empty slot. [. . . ] This section provides information on the regulatory model identification number for your HP All-inOne; an FCC statement; and separate notices to users in Australia and Korea. Regulatory model identification number For regulatory identification purposes, your product is assigned a Regulatory Model Number. The Regulatory Model Number for your product is SDGOB-0401-02. This regulatory number should not be confused with the marketing name (HP PSC 1400 All-in-One series) or product number (Q5786A). FCC statement The United States Federal Communications Commission (in 47 CFR 15. 105) has specified that the following notice be brought to the attention of users of this product. Declaration of Conformity: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ]