User manual HP STORAGEWORKS 300 VIRTUAL LIBRARY SYSTEM EVA GATEWAY STORAGEWORKS 300 GATEWAY VIRTUAL LIBRARY SYSTEM INSTALLATION (AH138-96001, NOVE

[. . . ] CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in their containers until needed. Ensure that you are properly grounded when touching static sensitive components. RACK REQUIREMENTS: HP supports the HP System E racks and the HP 10000 Series racks for use with the virtual library system (VLS). [. . . ] Use a #1 Phillips screwdriver and the four M4 screws (included) to attach the mounting brackets to the switch. 4. At the front of the rack, slide the clip onto the rack so that the hexagonal hole is facing out and align the holes in the clip with the proper hole in the rack. Then align the rail hole with these holes. 5. Push the screw through the rail, clip, and rack, then into the nut. Using a #2 Phillips screwdriver, tighten the screw to secure the rail to the rack. Repeat for the opposite rail. 11 Install cables on the primary node of the VLS300 Gateway 1 2 3 4 10 11 9 Attach rails to the 2824 switch 5 6 7 8 9 1. Align the inner rail with the switch so that the perpendicular screw hole faces away from the switch but is parallel to the switch bezel (face-plate). The two holes at the front of the rail must align with the two holes at the front of the switch. Insert two of the pan-head screws through the slide rail and into the switch at the front of the switch. Insert two of the pan-head screws through the appropriate holes in the slide rail and into the switch at the back of the switch. Perform these steps again to install the other rail on the other side of the node. Dual port FC card, host port, port 0 Dual port FC card, host port, port 1 Dual port FC card, device port, port 3 Dual port FC card, device port, port 2 Serial port to access CLI Monitor and keyboard ports NIC1, on primary node only connects to the customer-provided external network 8) NIC2, on primary node connects to port 1 of switch 2824 9) USB port, connects to USB/Ethernet adapter, then to port 1 of switch 2524 10) Power supply 2 11) Power supply 1 NOTE: FC ports (items 1-4 in the figure above) are not ordered consecutively. Pay close attention to the actual order of the ports when connecting cables. Connect one end of an Ethernet cable (not included) to NIC1 (item 7 in the figure above). Connect the other end of the cable to the existing external network. Connect one end of an FC cable (not provided) to host port 0 (item 1 in the figure). Connect the other end to an external FC switch/fabric that connects to your tape backup hosts. If desired, connect one end of an FC cable (not provided) to host port 1 (item 2 in the figure). Connect the other end to an external FC switch/fabric that connects to your tape backup hosts. Otherwise, connect a loopback plug to host port 1. Connect one end of an FC cable (not provided) to device port 3 (item 3 in the figure). Connect the other end to an external FC switch/fabric that connects to your external array. Connect one end of an FC cable (not provided) to device port 2 (item 4 in the figure). [. . . ] Connect an Ethernet cable to the Ethernet end of the adapter, then connect the Ethernet cable to port 2 of Switch 2524. Connect a power cable to each power supply (items 7 and 8 in the figure above) on the node and to a PDU. If possible, connect to separate PDUs to provide redundancy. NOTE: For each additional node, connect cables from NIC2 and the USB port to the next available ports on both switches. [. . . ]