User manual HP STORAGEWORKS 9000 VIRTUAL LIBRARY SYSTEM STORAGEWORKS 9000 VIRTUAL LIBRARY SYSTEM NODE INSTALLATION INSTRUCTIONS (AG306-

[. . . ] HP Brand HP StorageWorks 9000 Virtual Library System node installation instructions IMPORTANT: HP recommends you install the components of the VLS9000 in the following order: 3 2 26 FC Port 0 FC Port 1 DIRTY CLEAN 10/100 BASE-T STATUS DIRTY CLEAN 1 11778 1. 3. Array enclosures Fibre channel and network switches Node(s) If you are installing a VLS9000­series device, this poster is the third step. Install the disk array enclosures if you have not already done so, using HP StorageWorks 9000-series Virtual Library System disk array installation. [. . . ] · The full weight of the rack rests on the leveling jacks. · The stabilizing feet are attached to the rack if it is a single-rack installation. · The racks are coupled together in multiple-rack installations. · Only one component is extended at a time. A rack may become unstable if more than one component is extended for any reason. CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in their containers until needed. Ensure that you are properly grounded when touching static sensitive components. Rack requirements: HP supports the HP 10000 Series racks for use with VLS9000. Other racks might also be suitable, but have not been tested. For adequate airflow within the rack, use appropriate high airflow inserts in rack cabinet doors and observe industry standard practices for adequate spacing between racks or rows of racks. AG306-96102 Page 1 If you are installing the node into a telco rack, order the appropriate option kit at the RackSolutions. com web site: http://www. racksolutions. com/hp. Follow the instructions on the web site to install the rack brackets. 1 2 3 4 node 0 node 1 node 2 node 3 Identifying product components Installing the node(s) 1 10 2 3 4 9 5 6 7 11739 8 Install the VLS9000­series node(s) above the fibre channel switches installed previously. · With Fibre Channel Switches 4/16q, install node 0 immediately above the switches. · With Fibre Channel Switches 4/10q, leave an empty 1U space between the fibre channel switches and node 0. This blank space is reserved for future expansion. Install the two outer slide rails into the sides of the rack above the 4 U connectivity kit. [. . . ] NOTE: Set aside the two fibre channel transceivers. Install them when directed to do so. Getting help For more information, see: · The HP StorageWorks 9000-series Virtual Library System user guide · The HP website: http://www. hp. com · Your nearest HP authorized reseller (locations and telephone numbers of these resellers are given on the HP website) · HP technical support telephone numbers: · In North America, 1-800-633-3600 · For other regions, telephone numbers are given on the HP website VLS9000­series node rack mounting order VLS9000 configurations include a maximum of 4 nodes in one rack, installed at the top. Install all nodes beyond the first four at the top of a second rack. 4 3 2 1 11795 Page 2 [. . . ]