User manual HP STORAGEWORKS E7000 NAS STORAGEWORKS NAS E7000 V2 MAINTENANCE AND SERVICE GUIDE

[. . . ] maintenance and service guide hp StorageWorks NAS e7000 v2 First Edition (April 2003) Part Number: 326209-001 This guide contains information for servicing the HP StorageWorks NAS e7000 v2. © Copyright 2003 Hewlett-Packard Development Company, L. P. Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. This document contains proprietary information, which is protected by copyright. [. . . ] Refer to "Opening and Removing the Rear Access Panel" in this chapter. Refer to "Removing the Front Access Panel" in this chapter. Refer to "Front Fan Cage" in this chapter. Loosen the two thumbscrews that secure the pass-through board to the removable media board and the side chassis wall (1). You may need to use a Torx T-15 screwdriver. Lift the pass-through board straight up and out of the chassis (2). NAS e7000 v2 Maintenance and Service Guide 69 Removal and Replacement Procedures 1 2 1 Figure 46: Removing the pass-through board Reverse steps 1 through 7 to replace the pass-through board connector. Diagnostics Display Board and Lightpipe To remove the removable media board: 1. Refer to "Powering Down the Server" in this chapter. Refer to "Extending the Server from the Rack" in this chapter. Refer to "Opening and Removing the Rear Access Panel" in this chapter. Refer to "Removing the Front Access Panel" in this chapter. Refer to "Processor Air Baffle" in this chapter. Refer to "Front Fan Cage" in this chapter. Refer to "Pass-Through Board" in this chapter. Eject all devices from the slimline drive bays. Refer to "Slimline Drives" in this chapter. Refer to "Power Button/LED Assembly" in this chapter. Loosen the two thumbscrews holding the removable media board (1). Slide the board to the rear of the unit until it stops, and then lift it up (2). 70 NAS e7000 v2 Maintenance and Service Guide Removal and Replacement Procedures 1 2 1 Figure 47: Removing the removable media board 12. Lift the board out gently, being careful of the slimline drive bay connector. Reverse steps 1 through 12 to replace the removable media board. Rear Fan Cage To remove the rear fan cage: 1. Refer to "Powering Down the Server" in this chapter. Refer to "Extending the Rack from the Server" in this chapter. [. . . ] Be sure you are following the instructions provided in the Factory-Installed Operating System Software Installation problem has occurred. Installation Guide. Remove the new hardware and complete the software installation. Then, reinstall the new hardware. Caution: The System Erase Utility causes loss of all configuration information, as well as loss of existing data on all connected hard drives. Before performing this operation, refer to the Servers Troubleshooting Guide for information on the System Erase Utility and the associated warning. Refer to the Servers Troubleshooting Guide for the following: Information you need to collect when diagnosing software problems and to provide when contacting support Instructions on how to upgrade your operating system and its drivers Information about available recovery options and advice on minimizing downtime 126 NAS e7000 v2 Maintenance and Service Guide Troubleshooting ROMPaq Disaster Recovery A corrupted system ROM requires that you recreate the ROM BIOS by a process called disaster recovery. This operation can be accomplished only when the system is in disaster recovery (emergency repair boot) mode. [. . . ]