User manual HP STORAGEWORKS MODULAR ARRAYS COMPAQ STORAGEWORKS HSG60 ACS SOLUTION SOFTWARE V8.6 FOR COMPAQ TRU64 UNIX INSTA

[. . . ] Compaq StorageWorks HSG60 ACS Solution Software Version 8. 6 for Compaq Tru64 UNIX Installation and Configuration Guide First Edition (June 2001) Part Number: AA-RMBHB-TE Compaq Computer Corporation © 2001 Compaq Computer Corporation. Compaq, the Compaq logo, and StorageWorks Registered in U. S. Microsoft, MS-DOS, Windows, Windows NT and Windows 2000 are trademarks of Microsoft Corporation. All other product names mentioned herein may be trademarks of their respective companies. [. . . ] The software asks if the displayed information is correct. If the displayed information is correct, select option y and press the Enter key. A message, asking if you would like to add another person to notify, appears. Select option n to end the dialog or y to add another person to notify. After you select option n, the system will start the new Agent. If the installation script detects a problem at Agent startup, it will alert you. You are asked if you are running Agent in a TruCluster environment. Installing and Configuring the HS-Series Agent 4­9 Final System Configuration 26. Do one of the following: If you are running the Agent in cluster, select option y. The software is configured to scan the SCSI-bus for subsystems at startup. If you are not running the Agent in a cluster, select option n. The software is configured to look at the storage. ini file at startup time. The storage. ini file contains the listing of your subsystems. NOTE: Compaq recommends that if you are running Tru64 UNIX 5. 1x, especially within a fabric, configure the software to scan the SCSI-bus at startup. When asked if running the Agent in a cluster, answer y. The system starts the new Agent. Enter the following and press the Enter key to unmount the CD-ROM: # cd / # umount /mnt Reconfiguring the Agent You can change your configuration using the SWCC Agent Configuration menu. To access this menu, enter the following command: # /usr/opt/SWCC510/scripts/swcc_config The following is an example of the menu . SWCC Agent Configuration Utility ---------------------------------------Options Available Are: 1) Add/Delete Client PC Information. 2) Modify Storage Subsystem Information. 8) Cluster/No Cluster Enter a number or 'q' to QUIT: 4­10 HSG80 ACS Solution Software Version 8. 6 for Compaq Tru64 UNIX Installation and Configuration Guide CAUTION: After you make a change to the configuration, such as adding a client system, you must stop and then start the Agent for your changes take effect. When you stop and then start the Agent, the Storage Windows for the subsystems connected to the agent system lose their connection. To regain that connection, close and then reopen the Storage Windows connected to the agent system after you restart the Agent. Table 4­6 Information Needed to Configure Agent Term/Procedure Adding a Client system entry Description For a client system to receive updates from the Agent, you must add it to the Agent's list of client system entries. The Agent will only send information to client system entries that are on this list. In addition, adding a client system entry allows you to access the Agent system from the Navigation Tree on that Client system. You need to tell the Agent the subsystem that it needs to monitor. Network names for the computers on which the Client software runs. [. . . ] Upper Layer Protocol. Glossary­19 ULP process A function executing within a Fibre Channel node which conforms to the Upper Layer Protocol (ULP) requirements when interacting with other ULP processes. A unit may be created from a single disk drive or tape drive. A unit may also be created from a more complex container such as a RAIDset. The controller supports a maximum of eight units on each target. [. . . ]