User manual HP STORAGEWORKS SB40C STORAGE BLADE

[. . . ] The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. Blade with video and USB devices with local KVM . [. . . ] Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The card type determines where it can be installed in the server blade. optional mezzanine cards enable network connectivity and provide Fibre Channel support. For mezzanine card locations, see System board components on page 48 for more information. ⷠInstall Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector. Figure 6 Removing the mezzanine connector cover 5. Press down on the connector to seat the board. Use the local I/O cable to connect a monitor and any of the following USB devices: · This section offers two possible configurations. CAUTION: Before disconnecting the local I/O cable from the connector, always squeeze the release buttons on the sides of the connector. NOTE: For this configuration, a USB hub is not necessary. Figure 8 Connecting with a local KVM Table 4 Local KVM connection components Item Use the following configuration when configuring a server blade or loading software updates and patches from a USB DVD-ROM or a USB diskette. Figure 9 Connecting with local media devices Table 5 USB Hub devices Item NOTE: For more information about hardware and cabling configurations, see the documents that ship with the c-Class enclosures. Its features are accessed from a network client device using a supported web browser. This design makes iLO 2 independent of the host server blade and its OS. ILO 2 provides remote access to any authorized network client, sends alerts, and provides other server blade management functions. Using a supported web browser, you can: · Remotely power up, power down, or reboot the host server blade. Launch a web browser, use SNMP alerting, and diagnose the server blade with HP SIM. ⷠConfigure static IP bay settings for the dedicated iLO 2 management NICs on each server blade in an enclosure for faster deployment. The System Recovery DVD is used to restore the system to factory defaults. You may boot from the DVD and restore the system to the factory condition at any time. This allows you to recover the system if all other means to boot the system fails. While the recovery process makes every attempt to preserve the existing data volumes, you should have a backup of your data if at all possible before recovering the system. [. . . ] A risk of fire and burns exists if the battery pack is not properly handled. Do not expose the battery to temperatures higher than 60°C (140°F). ⷠDo not disassemble, crush, puncture, short external contacts, or dispose of in fire or water. table 15 Battery replacement notice Batteries, battery packs, and accumulators should not be disposed of together with the general household waste. [. . . ]