User manual HP SURESTORE 4/48 TAPE LIBRARY

[. . . ] HP DLT Tape Library 28/48-Slot User's Guide Models A4850A and A4855A November 1997 Printed in USA © Copyright 1997 Hewlett-Packard Company DLT and DLTtape are trademarks of Quantum Notice This document contains information that is protected by copyright. No part of this document may be photocopied, reproduced, or translated into another language. The information contained in this document is subject to change without notice. See Appendix B for important safety and regulatory information. Printing History New editions of this manual incorporate all material updated since the previous edition. [. . . ] This process takes about one minute. Security Configurations Some security configurations may prevent the bulk load access door from being released. If a security option is enabled, SECURITY ENABLED displays. If the drives contain cartridges, DRIVE(s) FULL displays after the RELEASE DOOR option is chosen. To open the bulk load access door when a security option prevents the door from being released, use the OVERRIDE DOOR option under the ADMIN* menu (see Figure 4-2 on page 4-6). 4-22 Library Operation Cleaning the Tape Drives Cleaning the Tape Drives 1 2 3 4 ADMIN* PSWD 000-000-000 CLEAN DRIVES* Cleaning the tape drives, which takes about 5 minutes per drive, requires a special digital linear tape cleaning cartridge. (Typically, cleaning cartridges are light yellow and data cartridges are black, brown, or white. See Appendix A for a list of supplies. ) The drive mechanisms do not require scheduled cleanings and should be cleaned only if a "clean drive" status indicator ( C ) displays after the drive number. If the cleaning cartridge needs to be replaced, REPLACE CLEANING displays, and the cleaning cartridge ejects through the mailslot. NOTE The software package may manage tape drive cleaning. Verify that the drive status displays (if not, press CANCEL until it does). Make sure all drives are empty ( displays after the drive number). To empty the drives, refer to the documentation for the software package. Press NEXT until ADMIN* displays, then press ENTER. Enter the three-part numerical password (see "Entering the Administration Menu Password" on page 4-7). Library Operation 5. Press NEXT until CLEAN DRIVES* displays, then press ENTER. If a cleaning cartridge is not loaded into the library, INSERT CLEANING displays. Load a cleaning cartridge into the mailslot. (See "Loading Cartridges Into the Library" on page 4-14 for additional information. ) If an error message displays when trying to load the cartridge, see the following section. CLEAN DRIVE 1 displays (the 1 is flashing). Press NEXT or PREV until the drive number to clean displays, then press ENTER. To clean all the drives, press NEXT or PREV until CLEAN DRIVE ALL displays, then press ENTER. 4-23 Library Operation Cleaning the Tape Drives NOTE If the drive(s) are not empty, a DRIVE FULL message displays. The drives must be emptied before they can be cleaned. If the cleaning cartridge slot did not contain a cleaning cartridge, NOT CLEAN CART displays briefly, and then CLEAN FAIL # displays. Press CANCEL twice to return to the "ready" state. [. . . ] Om apparaten används på annat sätt än i bruksanvisning specificerats, kan användaren utsättas för laserstrålning som överskrider gränsen för laserklass 1. Huolto HP DLT Tape Library -nauhamuistiasemien sisällä ei ole käyttäjän huollettavissa olevia kohteita. Laitteen saa avata ja huoltaa ainoastaan sen huoltamiseen koulutettu henkilö. Nauhamuistiaseman sisälle asennettua viivakoodinlukijaa ei tule avata eikä purkaa huoltotoimenpiteiden yhteydessä. [. . . ]