User manual HP SURESTORE 40FX OPTICAL JUKEBOX ADDING 1 DRIVE TO THE C1100 SERIES JUKEBOX - C1156-90000

[. . . ] FTP this code from hpgrsg. gr. hp. com (15. 38. 89. 10) using an "anonymous" login. Further download instructions are available at that address. * A PC with a SCSI interface and appropriate cables * A utility to download the code - DOWNLD2 or HP TOOLSET (Version 1. 95ce or later) from CoComp HP Part No. C1156-90000 Printed in USA June, 1996 Edition 1 0696 ©Hewlett-Packard Company, 1996 Adding 1 Drive to the C1100 Series Jukebox ESD Precautions The optical disk jukebox contains very sensitive electrical components. [. . . ] Slots on the bottom of the cover will slide off their rests. Pull the cover back and away from the chassis. ***** Removing screws on back panel to release top cover ***** Figure 1: Removing the outside cover 5 3. Remove the 8 T-15 screws on the top, bottom and sides of the access panel. Remove the access panel *********** Removing the Access Panel ************ Figure 2: Removing the access panel 4. Pull the picker up to the top of the chassis and insert a T-25 screw in the service hole, which holds the picker at the top of the chassis (Figure 3). ***** Fastening the picker out of the way ***** Figure 3: Fastening the picker to the service position 6 5. Remove the 3 cartridge "stop" screws (T-15). Figure 4: Cartridge "stop" screws Accessing Components in the Front Bezel 6. Remove the two T-25 screws that secure the front bezel to the chassis. These screws are located behind the bezel as shown in Figure 5. Figure 5: Front bezel mounting screws 7 7. Rotate the front bezel out and disconnect the front panel cable and the mailslot sensor cable. NOTE A tab on the top of the mailslot sensor cable must be released before the cable can be unhooked. Insert a small screwdriver and push this tab down (see inset in Figure 6). ***** Front Panel Tilted out ***** Figure 6: Front panel tilted out 8. Note The cables/connectors for the additional drive are already in place in the jukebox. You will only have to mount the drive and connect it to the cables. 8 Figure 7: Front RFI shield Figure 8: Drive DIP switch settings 9. Check the DIP switches on the rear of the drive. Make sure they are set to the positions shown in the diagram. The right-end switch on the rearmost DIP switch is set to the ON position. Slide the drive into the the jukebox chassis just above the current drive. Insert 1 T-10 screw through the right side of the chassis to support the drive . [. . . ] Re-mount the access panel and outside cover. 10 20. Label the jukebox as shown in Figures 10 and 11. Select the appropriate label -- Use the C1115 label when upgrading a C1100 (single-ended interface) jukebox. Use a C1116 label when upgrading a C1101 (differential interface) jukebox. Figure 10: Location of the product label Figure 11: Adding the upgrade label 21. [. . . ]