User manual HP SURESTORE S10 HUB

[. . . ] Service and User Manual Hewlett-Packard SureStore E Hub Models S10 and L10 Hewlett-Packard SureStore E Hub Models S10 and L10 Service and User Manual Edition E0899 Order No. A3724-90006 Printed in U. S. A. Notice © Hewlett-Packard Company, 1997, 1998, 1999. Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. [. . . ] Return to Main Menu Select IP address [current = nnn. nnn. nnn. nnn] Select Subnetworking Mask [current = nnn. nnn. nnn. nnn] Select Default Gateway address [current = nnn. nnn. nnn. nnn] Save Network Setup changes and reboot Proxy Master Setup 3. 9. Enter 2 to set the hub IP address. Type the IP address for the hub, then press <ENTER>. Type the Subnetworking Mask for the hub, then press <ENTER>. Enter 4 to set the Default Gateway address. Type the Default Gateway address for the hub, then press <ENTER>. The hub is rebooted with the new values. If you do not want to change the hub values, do not enter 5. Instead, enter 1 to return to the Main menu. Caution Verifying and Setting SNMP Values Use the following procedure to set the following SNMP values. If you have hubs in a cascaded configuration, only perform this procedure for the parent hub. The parent hub should be the hub that has the LAN (ethernet) connection. Refer to the values you entered in Table 1 on page 42 as you set the above parameters. · get community name 58 Enabling Hub Management The get community name must be the same name used when a device was added to Fibre Channel Manager. If the names are not identical, Fibre Channel Manager cannot report management information for this hub. The default value is public. · set community name The set community name must be the same name used when a device was added to Fibre Channel Manager. If the names are not identical, Fibre Channel Manager cannot set management parameters for this hub. The default value is private. · SNMP trap community name The hub includes the trap community name in event messages sent to the management application. The default value is SNMP_trap. · trap server IP addresses This option sets the destination addresses for SNMP event messages. A maximum of four addresses can be specified. Caution If you enter the name of an existing IP address, the existing address is deleted. · MIB-2 system name This value is returned for the SNMP MIB-2 system. sysName variable. RS-232 Interface Functions · default values This option resets the get, set, and trap community names to the default values. To verify and set SNMP values, do the following: 1. Verify with your network administrator that the default get community name is acceptable. Verify with your network administrator that the default set community name is acceptable. Verify with your network administrator that the default trap community name is acceptable. The default is SNMP_trap. Enabling Hub Management 59 4. From the Main menu, enter 3 (Management options) to display the Management Options menu: Management options Menu: 1. [. . . ] In a cascaded hub topology, the parent hub is the hub that is connected to the LAN (ethernet). HP SureStore E hubs are configured as a parent or child hub through their RS-232 interface. Short Wave Lasers or LEDs that emit light with wave lengths around 780 nm or 850 nm. Short-wave lasers are used for FC-AL links up to approximately 700 meters. [. . . ]