User manual HP VECTRA VE 5/XXX 4

[. . . ] This manual is for anyone who wants to: Set up the PC for the first time Configure the PC Add accessories to the PC Troubleshoot problems on the PC Find out where to get more information and support. WARNING If you have any doubt that you can lift the PC or display safely, do not try to move it without help. For your safety, always connect the equipment to a grounded wall outlet. Always use a power cord with a properly grounded plug, such as the one provided with this equipment, or one in compliance with your national regulations. [. . . ] Check if you are in a suspend/sleep mode, where by a "power-off" would risk a loss of information/data (refer to "Power Menu Items", in the HP Setup program --refer to "Using the HP Setup Program", on page 44). Wake up the PC first and then shut it down. This section describes what to do if you have problems with your display, disk drives, printer, accessory boards, keyboard, or mouse. This can happen if the video refresh rate is too high for your display. Use the HP Setup program to decrease the refresh rate for the video mode you are using. If the display works correctly during the Power-On-Self-Test (POST), but goes blank when Windows starts, your display's refresh rate may be set too high: 0 or Windows 95, you can start Windows in "safe mode" which will allow you to change the display settings. B If your display is not DDC compliant, Video Plug & Play display must be disabled. this option is in the Video section of the Advanced menu. Also, check the refresh settings in the Video section to ensure they are not too high. To check if your display is DDC compliant, refer to the manual supplied with your display. You can also change the refresh rate for the video mode you are using with the HP Setup program. If nothing is displayed on the display at all, but the PC starts and the keyboard, disk drives, and other peripheral devices seem to operate properly: Check that you have entered a password if you have set the keyboard and mouse to "locked". You can change this setting in the Setup program. Switch off the display, and unplug it from the power outlet. disconnect the video cable and examine the video cable connector pins. If the pins are bent, carefully straighten them. check that the video upgrade is properly installed if you have one. Check that an accessory board doesn't use the same I/O address as the integrated video interface (03B0h to 03DFh). Refer to the manual supplied with the accessory for further information. If the display image is not aligned with the screen, use the display's controls to center the image (refer to the display manual for instructions). If the screens generated by the applications do not appear to be correct, check the application's manual to find out which video standard is required. Also check your display manual to find out which refresh rate is required. [. . . ] (ii) The use of any operating system software by Microsoft contained in any such product recovery CD-ROM shall be governed by the Microsoft End User License Agreement (EULA). Customer may transfer rights in the software to a third party only as part of the transfer of all rights and only if Customer obtains the prior agreement of the third party to be bound by the terms of this License Agreement. Upon such a transfer, Customer agrees that his/her rights in the software are terminated and that he/she will either destroy his/her copies and adaptations or deliver them to the third party. Customer may not lease, sublicense the software or distribute copies or adaptations of the software to the public in physical media or by telecommunication without the prior written consent of Hewlett-Packard. [. . . ]