User manual HP VP6200

[. . . ] HP vp6200 Series Digital Projector User's Guide Notice © Copyright 2004 Hewlett-Packard Development Company, L. P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] The following standards are supported in the HDTV function: · · · 480i 576i 720p (50/ 60 Hz) · · · 480p 576p 1080i (50/ 60 Hz) 4. Connection 17 Connecting S-Video Devices Audio cable S-Video cable Connecting Composite-Video Devices Audio cable Composite -video cable If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, check that the video source is turned on and operating correctly. Also check that the signal cables have been connected correctly. 18 4. Connection Connecting to Display Devices If you want to monitor your presentation close-up on a monitor as well as on the screen, you can connect the VGA signal output port on the projector to an external monitor with a VGA cable. VGA cable 4. Switch all of the connected equipment on. Plug the power cord into the projector and into a wall socket. 3. 4. Turn on the wall socket switch (where fitted). Press Power on the remote control or projector to start the unit. The Power button flashes during warm up, then turns on solid. The projector searches the input ports for an input signal. A message on the screen shows the ports being searched. You can also press source on the projector or remote control to select your desired input signal. For more information, please refer to page 21. If the frequency or resolution of the input signal exceeds the projector's operating range, you will see the message "Out of Range" displayed on a blank screen. 5. 20 5. Press the Power button on the projector or remote control. The Power button flashes and the lamp shuts down, the fans continue to run for approximately 2 minutes to cool down the projector. To protect the lamp, the projector will not respond to any commands during the cooling process. 2. Disconnect the power cord from the wall socket. Do not unplug the power cord before the projector shutdown sequence is complete or during the 2-minute cooling down process. If the projector is not properly shut down, and you attempt to restart it soon after, the fans may run for a few minutes to cool down. Press Power again to start the projector after the fans stop. Source Selection To sequentially select input sources, press source on the projector control panel or the remote control. It may take you a few seconds when the projector is searching for input signals. The selected source will be displayed at the bottom right of the screen for 3 seconds. For a quick search, you can also press the key repeatedly until your desired signal is displayed. 5. Operation 21 Keystone Correction Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs when the projector is not perpendicular to the screen. To correct this, besides adjusting the height of the projector, you will need to manually correct it following one of these steps. [. . . ] If the lamp breaks, adequately ventilate the area where the breakage occurred. Disposal of this lamp may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance (www. eiae. org). Regulatory information This section presents information that shows how your digital projector complies with regulations in certain regions. Any modifications to your digital projector not expressly approved by Hewlett-Packard could void the authority to operate the digital projector in these regions. U. S. A. This digital projector has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]