User manual HP W19

[. . . ] HP w19 LCD Monitor User's Guide · · · · · · · · · Preface Safety and Maintenance Guidelines Setup Using the Monitor Drivers and Auto-Adjustment Technical Support FAQ Specifications LCD Monitor Quality and Pixel Policy Agency Regulatory Notices The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. HP assumes no responsibility for the use or reliability of its software on equipment that is not furnished by HP. [. . . ] If your monitor displays an image, installation is complete. If it does not display an image, see Technical Support FAQ and Using the Monitor. Back to Contents Page Attaching Wall Mounting Arm: HP w19 LCD Monitor Preparing to Install An Optional Wall Mounting Arm (Not supplied) · Installing an Optional Wall Mounting Arm (Not supplied) Preparing to Install An Optional Wall Mounting Arm (Not supplied) This monitor can be attached to a wall mounting arm you purchase separately. Follow these steps: 1 Set the monitor screen down on a flat, soft, protected surface. 2 Support the base and remove the screws. 4 Follow the manufacturer's instructions to assemble the wall mounting arm. See Installing an Optional Wall Mounting Arm for further installation instructions. Installing an Optional Wall Mounting Arm (Not supplied) Follow these steps to finish installing a wall mounting arm (not included): 1 Set the monitor screen down on a flat, soft, protected surface. 2 Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm with the holes in the back of the monitor. 3 Insert the 4 screws into the holes and tighten. Refer to the user's manual that came with the optional wall mounting arm for instructions on attaching it to the wall. Back to Contents Page Using the Monitor: HP w19 LCD Monitor · Setting the Optimal Resolution · Controls and Indicators Back to Contents Page Setting the Optimal Resolution: HP w19 LCD Monitor The recommended resolution for this monitor is 1440 by 900. To setup the monitor to this resolution, follow the steps below. Set the resolution SLIDE-BAR to 1440 by 900. NOTE: If 1440 by 900 is not shown, download the monitor driver from the Web. See Using the Monitor for instructions. Back to Contents Page Controls: HP w19 LCD Monitor Operating Instructions · External Controls · OSD Lock Function · How to Adjust a Setting · Adjusting the Picture · LED Indicators Operating Instructions Press the power button (E) to turn the monitor on or off. The other control knobs are located at front panel of the monitor (See Figure). By changing these settings, the picture can be adjusted to your personal preferences. · The power cord should be connected. · Connect the video cable from the monitor to the video card. · Press the power button (E) to turn on the monitor. The power indicator will light up. External Controls A B C D E Auto Config / Exit Brightness Contrast Menu / Enter Power Button OSD Lock Function To lock the OSD, press and hold the Menu button while the monitor is off and then press power button to turn the monitor on. To un-lock the OSD -- press and hold the Menu button while the monitor is off and then press power button to turn the monitor on. How to Adjust a Setting 1 Press the Menu button to activate the OSD window. 2 Press or to navigate through the functions. Once the desired function is highlighted, press the Menu button to activate it. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. [. . . ]