User manual HP W2371D

[. . . ] Microsoft, Windows, and Windows Vista are either trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. [. . . ] Mode Display Displays the resolution, refresh rate and frequency Information on the screen each time the OSD Main Menu is accessed. select: • • On Off The factory default is On. Monitor Status Displays the operating status of the monitor each time the monitor Is powered on. Select the location to display the status to: • • • • Top Middle Bottom Off The factory default is Top. DDC/CI Support Allows the computer to control some OSD menu features such as brightness, contrast and color temperature. set to: • • On Off The factory default is On. Bezel Power LED Volume Turns off the power LED on the front panel of the monitor. Adjusts the volume level, (on select models) 14 Chapter 4. Operating the Monitor ENWW OSD MENU Icon Main Menu Submenu Sleep Timer Description Provides the timer adjustment menu options: • • • • • Language Information Current Settings Recommended Settings Serial Number Set Current Time-sets the current time in hours and minutes Set Sleep Time-sets the time you want to place the monitor In sleep mode Set on Time-sets the time you want the monitor to wake up from sleep mode Timer-sets the Sleep Timer feature On or Off. The default setting Is Off Sleep Now-Immediately sets the monitor to enter sleep mode Selects the language in which the OSD menu Is displayed. Provides the recommended resolution mode and refresh rate for the monitor. Reports the serial number of the monitor. The serial number Is needed if contacting HP technical support. Reports the firmware version of the monitor. Reports the total hours of backlight operation. Com/support Returns all OSD menu settings and DDC/CI controls to the factory default settings, except the Language. Selects the default or primary video input signal when the monitor is connected to two active and valid video sources. The monitor will automatically determine the video format. The choices are: • • Auto-Switch Source DVI VGA FW Version Backlight Hours Service Support Factory Reset Source Control (on select models) Turns the system's automatic video signal input to On or Off. Exit ENWW Using the On-Screen Display (OSD) 15 Selecting Video Input Connectors The input connectors are: • • VGA connector (analog) DVI-D connector (digital) (Select Models) The monitor automatically determines which inputs have valid video signals, and displays the image. You can connect the VGA cable, the DVI-D cable, or both. If both cables are installed, the default input selection is DVI. [. . . ] The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country where you purchased the equipment. If you need to obtain a power cord for a different country, you should purchase a power cord that is approved for use in that country. The power cord must be rated for the product and for the voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. [. . . ]