User manual HP XW6000

[. . . ] Adaptec SCSI RAID 2120S/2200S Software User's Guide R Copyright © 2002 Adaptec, Inc. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written consent of Adaptec, Inc. , 691 South Milpitas Blvd. , Milpitas, CA 95035. Trademarks Adaptec and the Adaptec logo are trademarks of Adaptec, Inc. , which may be registered in some jurisdictions. Windows NT, Windows 2000, Windows. NET and Windows XP are trademarks of Microsoft Corporation in the US and other countries, used under license. Red Hat® Linux® consists of hundreds of software modules, some developed by Red Hat and many developed by other members of the open source community. [. . . ] Verify with Fix--Performs a test of the entire drive to ensure that there are no problems. Any data previously on the drive is not recoverable, and if all or part of the drive is used in an array, data integrity of the array will be compromised. Array Verify--Performs a test of the entire array to ensure that data is consistent. Any inconsistency found is not repaired. Verify with Fix--Performs a test of the entire array to ensure that data is consistent. Any data previously on the array is not recoverable. 3-28 Adaptec Storage Manager-Browser Edition To create a task: 1 2 3 4 5 6 Select the array or drive you want the task to run on. Select the type of task from the drop-down list. If you want the task to start immediately, click OK. Or, if you want to schedule the task for later, select Schedule. If you select Schedule, additional options will appear that will allow you to see the day of week and time you want the task to start, as well as the time format. Once you have selected the time and day, click OK. About Adaptec Storage Manager Notifier Service Adaptec Storage Manager - Browser Edition includes a notifier service that enables controller events to be added to the system event log. This service can notify users, through e-mail, of controller events. When you install Adaptec Storage Manager on a system equipped with an Adaptec Advanced RAID controller, the notifier service is installed and configured to log all events to the system event log. The default installation has email event notification disabled. Notifier Service Event Levels Adaptec Advanced RAID controllers support three event levels: Critical Warning Informational The level(s) of events entered in the system log and received by each user is configured independently. 3-29 Adaptec SCSI RAID 2120S/2200S Software User's Guide The notifier utility is named slightly differently depending on which operating system you are using. For all versions of Microsoft Windows the utility is named notify. exe, while for Novell NetWare it is named notify. nlm, and for all Linux and Unix variants it is named anotifyd. All versions of the utility support the -c switch. This switch runs the notifier in a configuration mode that leads you through the steps necessary to configure the system event log and e-mail notification. In addition to -c, the Microsoft Windows version of the notifier supports the switches in Table 3-2. Table 3-2 Switches -c -?-i Starts the notifier in configuration mode. Lists the switches supported by the notifier. Install - installs the notifier service. If the service has been uninstalled for any reason, this switch will install the service and set it to start automatically from the next boot. Uninstall - removes the notifier service. [. . . ] single-level array Array created from one or more segments. See also volume, RAID 0, RAID 1, RAID 5. Self-Monitoring Analysis and Reporting Technology. This technology is a drive feature designed to determine the reliability status of a disk. [. . . ]